Diamond Tech International Diamond Max Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Amoladora Diamond Tech International Diamond Max. Diamond Tech International Diamond Max 4 páginas. Diamond max two-in-one grinder operations manual

Imprimir página

1. Fill the water reservoir about 3/4 of the way to the top and

when ready to start disk grinding, open the Slide Valve. If needed,

you can increase water supply to the grinding disk by slightly

enlarging the holes located behind the slide valve. Use caution to

prevent over-enlargement of the holes.

2. While grinding, hold glass firmly and move material from side to

side over disk. To grind accurate 30

reversible Bevel Block. To grind an accurate 90

material against the back of the water reservoir.

3. If the material you are grinding rubs against the sides of the grinder,

then raising the disk is necessary. To raise the disk, first remove the

Grind Head, water reservoir, and retaining nut and the disk. The

support collar is secured by 2 hex screws on the side, loosen it and

raise the lower collar to the needed height, then retighten.

4. To avoid unnecessary disk vibration, ensure a secure fit between the disk and lower support collar.

5. Minor chipping may occur with new disk. Chipping will stop after a little use.

How To Drill

1. Start with the 1/4 grinder head attached to the top of the shaft.

2. Grip the glass firmly suing the lower very gently on the top of the drill

hold the wet sponge as close as possible to the point of contact .

3. Lighten pressure downward when you near completion of your drilling

to avoid chipping.

1. NEVER GRIND DRY. Always make sure the sponge for the router bit is wet or that water is dripping

on the disk while grinding.

2. DO NOT OPERATE WITHOUT DIAMOND DISK INSTALLED. Disk acts as a cover to keep water from

dripping on the motor housing.

3. While using the grinder head, use only light to medium pressure on the head. Do not push material

against head using excessive force. Unnecessary pressure will shorten grinder and grander head life.

4. Clean water reservoir and Super Sponge after each use.

5. If the router Grinding Head becomes dry, add water directly to the Super Sponge.

6. To maintain ease of assembly, disassembly, and to extend the life of the grinder, clean and grease

the motor shaft (rod that holds grinder head). Inner disk circle, and set screws every 50 hours of use.

7. Some rust may form onto he Diamond Disk, it does to effect the efficiency of life of the disk.

8. DO NOT GRIND METAL. It will make the surface unsuitable for glass in seconds.

Disk Operating Instructions

or 45

edges, use the

flat edge hold

bit,

Use and Care Information