BIOMET GPS III Manual

Navegue en línea o descargue pdf Manual para Equipos de laboratorio BIOMET GPS III. BIOMET GPS III 2 páginas. Platelet separation system

Imprimir página

Process Steps

Step One: Blood Draw

Step Two: Load Blood

Unscrew cap on center port No.1 and discard

Attach supplied 18 gauge needle to 60ml

syringe. Withdraw 5ml of ACD-A (citrate

green packaging post.

anticoagulant). 55ml of blood is then drawn

Slowly load blood into center port.

from the patient according to facility protocol.

Mini GPS® III System:

Attach supplied 18

gauge needle to 30ml syringe. Withdraw 3ml

of ACD-A. 27ml of blood is then drawn from

the patient according to facility protocol.

Spin

Close the lid by rotating the lid latch Clockwise. "Latched" indicator

will illuminate. The speed (3200 RPM) and time (15 minutes) are

preset. Press green button to start spin. Once spin is complete,

press red button to illuminate the "Unlocked" indicator. Twist latch

counter-clockwise to open lid.

Platelet Separation System

Remove protective cover on white cap and

discard. Screw white cap onto center port.

Step Four: PPP Extraction

To extract the platelet poor plasma (PPP), remove yellow cap on side

port No. 2 and connect the 30ml syringe. Slowly tilt the tube while

withdrawing. Replace yellow cap.

Push Open/Stop button on control panel. The "unlocked" indicator

will illuminate. Turn latch counter-clockwise to open lid. Place tube

into centrifuge.

Mini GPS® III System:

If using the mini kit, mini purple buckets must

be inserted into the centrifuge.

PRP Suspension and Extraction

Remove red cap on side port No. 3 and

With 10ml syringe attached, suspend the

connect 10ml syringe. Withdraw 2ml.

platelets by gently shaking the tube for

30 seconds.

Mini GPS® III System:

Remove red cap on

side part No. 3 and connect 10ml syringe.

Withdraw 1ml.

Step Three: Balance

Fill GPS® III System counterbalance with 60ml of sterile saline and

place into opposite side of centrifuge.

Mini GPS® III System:

Fill purple mini Counterbalance with 30ml of

sterile saline and place into opposite side of centrifuge.

Extract the remaining platelet rich plasma

(PRP) contents into the attached 10ml syringe.