EasyPro EX11000 Manual de instalación y mantenimiento - Página 2

Navegue en línea o descargue pdf Manual de instalación y mantenimiento para Bombas para estanques EasyPro EX11000. EasyPro EX11000 4 páginas.
También para EasyPro EX11000: Manual de instalación y mantenimiento (4 páginas)

Imprimir página

We congratulate you on your choice of the EX High Power Pump! It has been carefully designed using the advantages of today's technol-

ogy and carefully constructed to give you the dependability of yesterday. To insure proper performance, we urge you to carefully follow

the instructions in this manual. If you have any questions, call your nearest distributor or EasyPro for assistance.

INSTALLATION

Please read carefully! When properly installed this pump will provide dependable trouble-free service.

1. Locate the pump as near the water source as possible. A ﬂ ooded suction situation is preferred. The pump is not self-priming, therefore, if the ﬂ uid level

is below the pump, a swing check valve must be installed and the pump primed prior to start-up. (Figure 2)

2. Mount motor base to a secure, immobile foundation.

3. Use only plastic ﬁ ttings on both the intake and discharge ports. Seal pipe connections with Teﬂ on™ paste. These ﬁ ttings should be self-supported

and in neutral alignment with each port. (i.e. Fittings must not be forced into alignment which may cause premature line failure or damage to the pump

volute.) For non-ﬂ ooded installations, a strainer basket and check valve are recommended.

4. Never restrict the intake. Keep both input and discharge lines as free of elbows and valves as possible. Always use pipe of adequate diameter. This will

reduce friction losses and maximize output.

5. The EX High Power Pump is not self-priming! It must not be run dry! We recommend a ﬂ ooded suction installation. Please read carefully! When properly

installed, the EX High Power Pump will provide dependable, trouble-free service.

(FIGURE 2)

WARNING: ALWAYS SHUT OFF ELECTRICAL POWER BEFORE INSTALLATION AND / OR SERVICING THIS PUMP! ALL

ELECTRICAL WIRING SHOULD MEET STATE AND LOCAL ORDINANCES. IMPROPER WIRING MAY NOT ONLY BE A

SAFETY HAZARD BUT MAY PERMANENTLY DAMAGE THE MOTOR AND/OR PUMP!

ELECTRICAL HOOK-UP

1. Check that supply voltages match the motor's requirements.

2. Check motor wiring and connect, according to instructions on motor, to match supply voltage.

3. Power cord should be protected by conduit or by cable and be of proper gauge. It should be no longer than necessary.

4. Power should be drawn directly from a box with circuit breaker protection or with a fused disconnect switch.

EX8500 & EX11000

BALL VALVE

SUCTION LIFT

PUMP

Reliability You Can Count On!

FLOODED SUCTION

SWING CHECK VALVE

WARNING: DO NOT RUN DRY!

Pg. 2