Bionaire BCH9222-CN Folleto de instrucciones - Página 3
Navegue en línea o descargue pdf Folleto de instrucciones para Calentador Bionaire BCH9222-CN. Bionaire BCH9222-CN 11 páginas. With advanced touchscreen control
Imprimir página
A S S E M B LY I N S T R U C T I O N S
PLEASE READ AND SAVE
THESE IMPORTANT SAFETY
INSTRUCTIONS
TECHNICAL SPECIFICATIONS
• Amps: 12.5
• Wattage: 1500W (+5% –10%)
• Working voltage: 120V AC/60Hz
NOTE: Low Heat setting may be 1000W on some models.
ASSEMBLY INSTRUCTIONS
NOTE: A Phillips screwdriver is required for assembly.
Unpack your heater from the box, being careful to remove
all parts from plastic bags and remaining packaging. Please
save the carton for off-season storage.
Some models are packed with separate base and pedestal in
the box. Carefully remove all parts from plastic bags. To
prevent scratches, place all parts onto a cloth before assembly.
Follow the below instructions for Pedestal/Base assembly:
Pedestal Assembly (if no pedestal is included in this
model, move to Base Assembly)
Step 1:
Run the power cord through the center of the
assembled pedestal. Snap pedestal into the
bottom of the heater housing. Refer to Figure 1, 2.
Base Assembly
Step 1:
If the base is in two halves, snap them together
by sliding slots of one base half into slots of
second base half. Refer to Figure 3.
Step 2:
Run the power cord through the center of the
assembled base. To assemble the base to the unit
(either one or two-piece base) first make sure
the side marked "Rear" is facing the back of the
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5