HTC 5004 Manual del usuario - Página 9

Navegue en línea o descargue pdf Manual del usuario para Instrumentos de medida HTC 5004. HTC 5004 11 páginas. Digital micro ohm meter

7. Data access/delete

After turning on or after the measurement, press the "

and the word "MR" is displayed below. Press the " " or " " key to set the step value to the corresponding

data of the storage data group of 1 group, and press the "

the corresponding data to the storage data group of 10 groups. Press "

this mode and return to the test mode, as shown in the figure below.

When checking, the small number in the figure below is the number of currently checked groups. If

there is no stored data, the LCD will display "NULL", see the figure below.

In the data access mode, press the "

" to select "NO" or "yES", select "NO" and then press "

deleting, select "yES" and press "

displayed .

8. Data upload

Connect the USB communication line between the computer and the instrument, turn on the

instrument, and run the host computer software. If the USB connection is successful, the stored historical

data can be read, uploaded to the computer and saved.

The upper computer software has functions such as historical data reading, consulting, and saving.

9. Line resistance calibration (removal of residual resistance)

Short-circuit the two clips first, wait for the displayed value to stabilize, and finally press the "

button for 2 to 3 seconds to complete the line resistance calibration. As shown below:

Note: You must wait for the displayed value to stabilize before long pressing the "

calibrate the line resistance.

" key to switch to the data delete mode. , Press "

" to delete the stored data. After deleting, the following figure will be

- 8 -

" key to switch to the data access mode,

" or "

" key to set the step value of

" or press "

" to return to the test state without

" twice to exit

" or

" key to