Bionaire BCM3855-CN COOL MIST Folleto de instrucciones - Página 3
Navegue en línea o descargue pdf Folleto de instrucciones para Humedezca Bionaire BCM3855-CN COOL MIST. Bionaire BCM3855-CN COOL MIST 9 páginas.
Imprimir página
F E AT U R E S - O P E R AT I O N S
26. Do not move unit after it has been used until unit cools
completely.
27. Use both hands when carrying full tank of water.
PLEASE READ AND SAVE
THESE IMPORTANT SAFETY
INSTRUCTIONS
CONSUMER SAFETY INFORMATION
NOTE: This is an electrical appliance and requires attention
when in use.
NOTE: If moisture forms on the walls or windows of the
room, turn off the humidifier. The room already has plenty of
humidity and additional moisture may cause damage.
NOTE: DO NOT block air inlet or outlet.
Cord and Plug Installation Safety Instructions:
The length of cord used on this appliance was selected to reduce
the hazards of becoming tangled in, or tripping over a longer
cord. If a longer cord is necessary an approved extension cord
may be used. The electrical rating of the extension cord must be
equal to or greater than the rating of the humidifier (refer to
the rating information placed on the humidifier). Care must be
taken to arrange the extension cord so that it will not drape
over the countertop or tabletop where it can be pulled on by
children or accidentally tripped over.
HOW COOL MIST WORKS
Your Bionaire
Cool Mist humidifier draws dry air through
®
the air intake grill area. This air is then passed through a
moisture–laden wick filter, which retains the minerals and
deposits in the water. The resulting moist air is directed back
into the room from the top air grill.
NOTE: This humidification system provides a cool,
invisible moisture output. It is normal not to see the
mist.
NOTE: A humidity level below 20% can be unhealthy and
uncomfortable. The recommended humidity level is between
40%-50%.
PRE-OPERATING INSTRUCTIONS
1. Be sure the humidifier is switched to OFF and the unit is
disconnected from the electrical outlet.
2. Choose a location out of reach of children. DO NOT place
the humidifier on a finished floor or near furniture which
can be damaged by moisture or water.
3. To ensure proper performance, make sure filter is fully
seated in water tray. Make sure filter support cap is also
in place (see Figure 1).
FILLING THE WATER TANKS
1. Remove the two tanks from the back of the humidifier
and bring each tank to the faucet. Turn the tank upside
down and twist off the large tank cap by turning
counter-clockwise. Fill each tank with cool, fresh tap
water. Replace the cap on each tank FIRMLY.
NOTE: Adding a water softening agent like Water Treatment
(Model S1705) to the water will soften mineral deposits and
prevent lime and scale build-up. It will also help prolong the
life of the wick filter and make cleaning easier.
2. When full, carry each tank by holding the handle on top
of each tank to the humidifier and place back to the unit
(use both hands when carrying each tank). Each tank
holds 1.87 Gallons of water. When the water stops
emptying, remove the tanks and refill each again.
Replace the tanks onto the humidifier housing. The
WATER LIMITING feature on the tank cap will prevent the
tanks from overflowing. YOU NOW HAVE 1.87 GALLONS
OF WATER IN EACH TANK FOR A TOTAL OF 3.74 GALLONS
OF WATER.
3. Plug the power cord into a 120V AC electrical outlet.
OPERATING INSTRUCTIONS
With the filter installed correctly (plastic filter support cap
placed on top of the filter - see Figure 1), front door closed,
the tanks filled and the plug correctly inserted in the outlet,
you are now ready to operate the humidifier.
NOTE: The humidifier produces clean, cool, INVISIBLE
moisture. It is normal not to see the moisture.