Bionaire BU1400 Manual de instrucciones - Página 7
Navegue en línea o descargue pdf Manual de instrucciones para Humedezca Bionaire BU1400. Bionaire BU1400 8 páginas. Ultrasonic humidifier
Imprimir página
back to the place of purchase, with your till
receipt and a copy of this guarantee.
The rights and benefits under this guarantee are
additional to your statutory rights, which are not
affected by this guarantee. Only Holmes
Products (Europe) Ltd. ("Holmes") has the right
to change these terms.
Holmes undertakes within the guarantee period
to repair or replace the appliance, or any part of
appliance found to be not working properly free
of charge provided that:
• you promptly notify the place of purchase or
Holmes of the problem; and
• the appliance has not been altered in any
way or subjected to damage, misuse, abuse,
repair or alteration by a person other than a
person authorised by Holmes.
Faults that occur through, improper use,
damage, abuse, use with incorrect voltage, acts
of nature, events beyond the control of Holmes,
repair or alteration by a person other than a
person authorised by Holmes or failure to follow
instructions for use are not covered by this
guarantee. Additionally, normal wear and tear,
including, but not limited to, minor discoloration
and scratches are not covered by this guarantee.
TROUBLE SHOOTING
PROBLEM
There is not
enough mist
Mist has bad odour
Abnormal noise
The rights under this guarantee shall only apply
to the original purchaser and shall not extend to
commercial or communal use.
If your appliance includes a country-specific
guarantee or warranty insert please refer to the
terms and conditions of such guarantee or
warranty in place of this guarantee or contact
your local authorized dealer for more
information.
Waste electrical products should
not be disposed of with
Household waste. Please recycle
where facilities exist. E-mail us at
for further recycling and WEEE
information.
Holmes Products (Europe) Limited
1 Francis Grove
London
SW19 4DT
UK
CAUSE
The Mist Control is on the
Lo
Setting
Resonance from the surface
bearing the unit
Scale covers the transducer
Dirty or stagnant water in tank
New appliance (out of the box)
Not fresh or filtered water for
proper results
Resonance effect due to too
little water in the water tank
Resonance from the surface
bearing the unit
6
SOLUTION
Change the Mist Control to
Hi
Setting (see Mist Control
instructions)
Place the unit on a steady
surface or
on the ground
Clean the transducer softly with
a damp cotton ball. Transducer
surface is delicate; avoid
applying excessive pressure.
Empty tank and refill with fresh
water
Open the water tank and place
the appliance in a cool area for
12 hours.
Wash the tank out or change
the water.
Refill water in the water tank
Place the unit on a steady
surface or on the ground