Alpha Microsystems AM-402 Manual de instrucciones de instalación - Página 5

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Equipos de grabación Alpha Microsystems AM-402. Alpha Microsystems AM-402 17 páginas. Scsi cd-recorder

Imprimir página
Installation Instructions: AM-402 SCSI CD-Recorder
If you have a CD player in your system, the ACD command used for reading AMOS CDs looks
for the CD player or recorder with the highest SCSI address. If you still want to read from that CD
player, make sure that you select a SCSI ID for the AM-402 which is less than that used by the CD
player.
While the Wide SCSI-2 bus supports IDs up to 15, the AM-402 is a narrow SCSI device. You
cannot set one to an ID higher than 6, even if it is attached to the Wide SCSI-2 bus with an
adapter.
Figure 1 shows how the AM-402 is addressed, on-board SCSI terminator enable control location, and the
location of the 50-pin SCSI drive connector and 4-pin power connector. For the majority of installations,
the SCSI ID jumpers are the only jumpers you should need to change to suit your particular system
configuration. See Figure 1 for standard jumper settings.
Yamaha CRW8424SZ model
AUDIO
OUT
CONFIGURATION
AUDIO
CONFIGURATION
OUT
50-PIN CONNECTOR
Eject Lock (jumper off)
Block Size (jumper off)
Test -factory use only (jumper off)
Enable SCSI termination (jumper off for external
SCSI Parity (jumper on)
SCSI ID 4 (install jumper for "1", remove jumper for "0")
SCSI ID 2 (
SCSI ID 1 (
SCSI ID 1 (install jumper for "1", remove jumper for "0")
SCSI ID 2 (
SCSI ID 4 (
SCSI Parity (jumper on)
Enable SCSI termination (jumper off for external
Block Size (jumper off)
50-PIN CONNECTOR
Yamaha CRW3200SZ model
Figure 1 - AM-402 CD-Recorder (Rear View)
PIN #1
DC POWER
SCSI termination)
"
"
"
"
"
"
"
"
"
"
"
"
"
"
"
"
"
"
"
"
SCSI termination)
DC POWER
PIN #1
Page 2
"
"
" )
"
"
" )
"
"
"
"
"
"
PDI-00402-00, Rev. A02