Axis exacqVision Edge Manual de inicio rápido - Página 4

Navegue en línea o descargue pdf Manual de inicio rápido para Servidor Axis exacqVision Edge. Axis exacqVision Edge 5 páginas.

14. On the IP Cameras page, verify that the camera is associated with its embedded server:



The IP address must be 127.0.0.1 so that the embedded server communicates with the local camera.



The camera's credentials are root and pass by default.



The status is displayed as Connected when complete.

15. See the exacqVision user manual for additional configuration steps, such as configuring recording settings.

Using Network Storage

exacqVision Edge can also save data to network attached storage (NAS) provided by the camera's operating system. (An SD card

must be installed even if you use NAS because critical exacqVision Edge processes run on the card.) To use NAS, make sure that:



the NAS is compatible with the camera and camera firmware.



the NAS is properly configured on the camera's web page.



the NAS provides adequate, stable Input/Output Per Second capacity for the camera's search, read, write, and delete

functions.

The procedure for enabling the NAS for use with exacqVision Edge is similar to the procedure in the previous section. To use NAS

with exacqVision Edge, complete the following steps:

1. Configure the NAS as described in the camera instructions provided by Axis.

2. Confirm that the NAS is properly mapped. To do this, open the camera's web page and select Setup, System Options, and

then Storage. Verify that the Total Size for Network Share is greater than zero, which means the camera is communicating

with the NAS. If the Network Share is "not defined," click the link to open Storage Management, enter the required

information, and click Ok.

3. Restart the exacqVision Edge server from the camera's Applications page by selecting Stop and then Start.

4. Verify that the exacqVision Edge server appears on the Storage Setup page in exacqVision Client and that its Enabled box is

selected.

NOTE: On exacqVision Edge systems with multiple drives (NAS and local SD card), data is initially saved to the drive with the

largest amount of free space. For example, if the NAS contains more free space than the SD card, exacqVision Edge saves data to

the NAS until the SD card has more free spaceоĂŶĚ ƚŚĞŶ ŝƚ ƐĂǀ ĞƐ ĚĂƚĂ ƚŽ ƚŚĞ ^ Đ ĂƌĚ ƵŶƟů ƚŚĞ E ^ ŚĂƐ ŵŽƌĞ ĨƌĞĞ ƐƉĂĐ Ğ͘ t ŚĞŶ Ăů ů

storage locations are full, exacqVision Edge deletes video from both locations to create free space. If the connection to the NAS

is broken, exacqVision Edge continues to save data to the local SD card.

www.exacq.com

+1.317.845.5710

USA (Corporate Headquarters)

+5255.56080817

Mexico

+44.1438.310163

Europe/Middle East/Asia

+31.485.324.347

Central Europe

Page 4 of 5

5/2/2012