Axis P7216 Manual de instalación - Página 9

Navegue en línea o descargue pdf Manual de instalación para Media Converter Axis P7216. Axis P7216 17 páginas. Video encoder

AXIS P7216 Video Encoder

Connectors

For specifications, see page 10.

BNC connector - Each video input is terminated using a coax/BNC connector. Connect a 75 Ohm

coaxial video cable; the recommended maximum length is 800 feet (250 meters).

Note

75 Ohm video termination can be enabled/disabled for the video input via the product's

web page at Video & Audio > Video Input > Video termination. This termination is enabled

on factory default. In cases where the product is to be connected in parallel with other

equipment, for optimum video quality, it is recommended that termination be enabled for

only the last device in the video signal chain.

Network connector - RJ45 Ethernet connector.

SFP connector - The unit can only use one Network interface, either an SFP module or RJ45

connector. SFP module has higher priority than the RJ45 connector.

NOTICE

The product shall be connected using a shielded network cable (STP). All cables connecting

the product to the network switch shall be shielded (STP) and intended for their specific

use. Make sure that the network switch is properly grounded. For information about

regulatory requirements, see Regulatory Information, on page 2 .

Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is

used from a stereo signal).

Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address

(PA) system or an active speaker with a built-in amplifier. A stereo connector must be used for

audio out.

SD card slot - A standard or high-capacity microSD card (not included) can be used for local

recording with removable storage.

NOTICE

To prevent corruption of recordings, the SD card should be unmounted before removal. To

unmount, go to Setup > System Options > Storage > SD Card and click Unmount.

Control button - The control button is used for:

•

Resetting the product to factory default settings. See page 14.

Connecting to an AXIS Video Hosting System service or AXIS Internet Dynamic

DNS Service. For more information about these services, see the User Manual.