DieHard 200.71315 Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Cargador de batería DieHard 200.71315. DieHard 200.71315 14 páginas. 15/2/125 amp fully automatic battery charger engine starter

Imprimir página

AMMETER:

The

ammeter indicates the measured amount of

amperes being drawn by the battery. When you first

start charging a battery, the reading will be high, with

the needle near 15 using the 15 amp charging rate.

In the MANUAL setting, as the battery charges, the

needle will fall to about 7 or 8 amps, indicating a

charged battery.

In either AUTOMATIC setting, the needle will fall to

zero and the charger will shut off when the

charger's control circuit senses a full charge. A

freshly charged battery's voltage will drop shortly

after charging, and the charger, if left connected,

may resume charging.

This off-and-on cycling will

continue until the battery's voltage no longer drops

enough to restart the charger.

•

At the 2 amp charging rate you will notice very little

needle movement.

When cranking the engine while using the ENGINE

START feature, the needle will swing into the Start (red)

area of the scale.

LED INDICATORS:

Two LED INDICATORS provide information on the state

of charge by glowing steadily or blinking at different

intervals.

GREEN,

FAST BLINK:

When the charger is charging a battery, the green LED

INDICATOR will blink rapidly approximately 4 times per

second.

GREEN,

STEADY:

In AUTOMATIC,

the green LED INDICATOR will glow

and the meter needle will be at zero, when the charger

has completed the charging cycle.

In MANUAL mode, YOU MUST monitor the charging

and stop the charging when the meter indicates about

half the selected rate, 2 or 15 amps. The charger has a

safety timer designed into the control, stopping the

charge upon reaching a maximum permitted time.

See chart to right.

GREEN,

SLOW BLINK:

The charger will be in the MAINTAIN mode when the

slow blinking green LED INDICATOR is operating. This

occurs only in the AUTOMATIC charging positions after

the end of the AUTOMATIC charging cycle, approxi-

mately 2 times per second.

RED, STEADY:

When the red LED INDICATOR glows steadily, it means

that the charger has not sensed a battery. The leads

may be reversed on the battery posts or one or both

connections may not be making a solid contact. Check

your connections.

DC AMPS

•

FULL

CHECK •

CHARGE

BATI'ERY

Rate,._,_ :,_M_mdm:Tlme,

20 HRS.

15A

16 HRS.

RED, SLOW BLINK:

If, after a pre-set number of hours, the charger fails to

fully charge a battery, it will give up and the red LED

INDICATOR will blink slowly to tell you that something

is wrong with the battery, approximately 2 times per

second.

RED, FAST BLINK:

A rapid blinking red LED INDICATOR informs you that

the charger cannot operate with your control setting.

For example the controls are set on 12V.

AUTOMATIC REGULAR, and ENGINE START. The

ENGINE START feature will operate only in the

MANUAL mode--the red LED INDICATOR will blink

rapidly, approximately 4 times per second.