DieHard 200.713151 Manual del usuario - Página 13

Navegue en línea o descargue pdf Manual del usuario para Cargador de batería DieHard 200.713151. DieHard 200.713151 17 páginas. 15/2/125 amp fully automatic battery charger engine starter

Imprimir página
Performance problems often result from
little things that you can fix yourself.
Please read through this chart for a possible solution
if a problem occurs.
No ammeter
reading
Circuit breaker in
charger
cycles on
and off with a
clicking sound in
MANUAL mode.
Ammeter
reads less
than selected
charge
rate when charging.
Clamps not making good
connection.
2-amp charge rate.
AC cord and/or extension
cord is loose,
No power at receptacle.
Shorted battery clamp_.
Shorted
battery.
Charger
leads reversed
on battery.
Extension cord too long or
gauge to small.
Battery has weak cell or
sulfated plate.
The red LED should be glowing steadily.
Check
for poor connection
at battery.
Make sure clamps and posts are clean.
Ammeter needle will show little or no
activity at the 2-amp charge rate.
Check power cord and extension
cord
for loose fitting plug.
Check for open fuse or circuit breaker
supplying AC outlet.
Circuit breaker cycles when current draw
is too high. Check for worn cables and
replace if needed.
The red LED should be blinking slowly.
Have a qualified technician test the
battery.
The red LED should be glowing steadily.
Correct connections to battery.
Use shorter or heavier extension cord.
Sulfated battery will eventually take a
normal charge if left connected.
If the
battery will not take a charge, the red
LED should be blinking slowly. Have a
Sears technician test the battery.
Battery is only partially
Continue charging battery.
charged.
Charger makes a
Transformer
laminations
Continue charging.
Buzz is not normal.
loud buzz.
vibrate (buzz).
Drawing more than 125
amps for 5 seconds or
less.
Failure to wait for 4 minutes
(240 seconds) between
cranks.
Short start cycle
when cranking
engine.
Crank time varies with the amount of
current drawn from the charger. If
cranking draws more than 125 amps,
crank time may be less than 5 seconds.
Wait 4 minutes before next crank.
If the above
solutions
do not eliminate
the problem...
call toll-free from anywhere
in the U.S.A.
1-800-SEARS-64
•
(1-800-732-7764)
7 AM to 4:30 PM CST Monday through
Friday
13