DieHard 71323 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Cargador de batería DieHard 71323. DieHard 71323 20 páginas. Battery charger and engine starter

Imprimir página

8. GROUNDING AND AC POWER CORD CONNECTIONS

8.1 This battery charger is for use on

a nominal 120 volt circuit. The

charger must be grounded, to

reduce the risk of electric shock.

The plug must be plugged into an

outlet that is properly installed and

grounded in accordance with all

local codes and ordinances. The

plug pins must fit the receptacle

(outlet). Do not use with an

ungrounded system.

8.2 DANGER: Never alter the AC

cord or plug provided – if it does

not fit the outlet, have a proper

grounded outlet installed by a

qualified electrician. An improper

connection can result in a risk of

an electric shock or electrocution.

NOTE: Pursuant to Canadian

Regulations, use of an adapter

plug is not allowed in Canada. Use

9. ASSEMBLY INSTRUCTIONS

9.1 Remove all cord wraps and uncoil the cables prior to using the battery charger.

10. CONTROL PANEL

LED INDICATORS

CLAMPS REVERSED (red) LED

flashing: The connections are

reversed.

CHARGING (yellow/orange) LED

lit: The charger is charging the

battery.

CHARGING (yellow/orange) LED

flashing: The charger is in abort

mode.

CHARGED/MAINTAINING

(green) LED pulsing: The battery

is fully charged and the charger is

in maintain mode.

NOTE: See the Operating

Instructions section for a complete

description of the charger modes.

of an adapter plug in the United

States is not recommended and

should not be used.

8.3 USING AN EXTENSION CORD

The use of an extension cord is

not recommended. If you must use

an extension cord, follow these

guidelines:

• Pins on plug of extension cord

must be the same number, size,

and shape as those of plug on

charger.

• Ensure that the extension cord

is properly wired and in good

electrical condition.

• Wire size must be large enough

for the AC ampere rating of

charger, as specified:

Length of cord (feet)

AWG* size of cord

*AWG-American Wire Gauge

RATE SELECTION

Use this button to set one of the

following:

• 6A<>2A CHARGE/MAINTAIN –

For charging small and large

batteries. Not recommended for

industrial applications.

• 10A BOOST – For quickly adding

energy to a severely discharged

or large capacity battery prior

to Engine Start. The unit will

automatically switch to 6A<>2A

Charge/Maintain after the 10A

Boost operation has completed.

• 50A ENGINE START –

Provides additional amps for

cranking an engine with a weak or

run-down battery. Always use in

combination with a battery.

• 6 •

100

150