Olympus BH2 Series Desmontaje, limpieza y montaje completos - Página 12

Navegue en línea o descargue pdf Desmontaje, limpieza y montaje completos para Microscopio Olympus BH2 Series. Olympus BH2 Series 23 páginas. Phase contrast
También para Olympus BH2 Series: Manual de solución de problemas y ajuste (46 páginas), Desmontaje, limpieza y montaje completos (40 páginas), Desmontaje, limpieza y montaje (45 páginas), Manual (6 páginas), Manual de instalación (9 páginas)

Figure 24 – Clean grease from side groove in focus block

Remove the Guide Rails from the Guide Block

Remove the two short guide rails from the side groove

in the guide block (see Figure 25).

Figure 25 – Remove guide rails from the guide block

Use a suitable solvent (e.g., acetone) to remove any

grease from two short guide rails (see

from the side groove in the guide block (see Figure 26).

Figure 26 – Clean grease from side groove in guide block

Clean the Cylindrical Rollers

Soak the cylindrical rollers in a suitable solvent (e.g.,

acetone) to remove all grease from the rollers (see

Figure 27).

Complete Teardown, Cleaning, and Reassembly of the Olympus BH‐2 Sliding Focus Block

Reassemble the Sliding Focus Block

Reassemble the sliding focus block mechanism per the

following procedure.

Reinstall the Guide Rails into the Arm Casting

Per the procedure described in

document, reinstall the four long guide rails into the

two side grooves of the arm casting (see Figure 28) and

remove any exposed grease from the four guide rails

(see Figure 29 and Figure 30).

Figure

19) and

Figure 27 – Soak the rollers in solvent to remove grease

Figure 28 – Reinstall the long guide rails into the arm

Figure 29 – Scrub grease from guide rails and arm

Appendix

1 of this

Revision 2

Page 12 of 23