Olympus BH2 Series Desmontaje, limpieza y montaje - Página 35

Navegue en línea o descargue pdf Desmontaje, limpieza y montaje para Microscopio Olympus BH2 Series. Olympus BH2 Series 45 páginas. Phase contrast
También para Olympus BH2 Series: Manual de solución de problemas y ajuste (46 páginas), Desmontaje, limpieza y montaje completos (23 páginas), Desmontaje, limpieza y montaje completos (40 páginas), Manual (6 páginas), Manual de instalación (9 páginas)

Use a suitable lens suction tool (item 9 of

to carefully install the clear adiabatic glass disk into the

metal barrel and seat it on the upper spacer tube (see

Figure

145).

Figure 145 – Install adiabatic disk into the metal barrel

Use a suitable lens spanner tool (item 8 of

to reinstall the upper retaining ring (the larger of the

two) into the metal barrel and snug it down against the

adiabatic glass disk (see

Figure 146 – Place upper retaining ring into position

Figure 147 – Snug upper retaining ring to the glass disk

The Light Inlet Assembly is now ready to be reinstalled

into the microscope stand (see

Teardown, Cleaning, and Reassembly of the Miscellaneous Parts of the Olympus BH-2 Microscope Frames

Appendix

Figure 146

and

Figure

147).

Figure

148).

Figure 148 – Ready to reinstall the Light Inlet Assembly

Reinstall Light Inlet Assembly (BHT/BHTU)

Observe the outer surface of the metal barrel of the

Light Inlet Assembly to find the two bite marks in the

circular depressions machined into the metal barrel (see

Figure

149). Since these bite marks were made by the

setscrews that originally secured the Light Inlet

Assembly in the correct location in the base casting,

they can be used as witness marks to reinstall the Light

Inlet Assembly back into its original location.

Figure 149 – Bite marks to act as alignment witness marks

Carefully insert the light inlet assembly into the bore of

the base casting, as shown in

Figure 150 – Insert Light Inlet Assembly into the bore

Figure

150.

Revision 1

Page 35 of 45