Olympus PFL-01 Manual de instrucciones - Página 30

Navegue en línea o descargue pdf Manual de instrucciones para Accesorios para cámaras Olympus PFL-01. Olympus PFL-01 39 páginas. Underwater case for the electronic flash fl-20

Imprimir página

7. Appendix

Q & A on the use of the PFL-01

Q1 : Which electronic flashes can be used with this case?

A1 : The PFL-01 case is designed exclusively for the FL-20 Electronic Flash.

Q2 : What points should be observed when inserting the electronic flash into

the case?

A2 : When inserting the flash you should pay special attention to the following points:

(1) Check that the flash's batteries are fully charged.

Insert the flash into the case's hot shoe properly and tighten the flash's

shoe lock dial.

(2) Before closing the case, check that the O-rings are correctly attached the

case.

(3) Make sure that the O-rings and contact surfaces are free of foreign

matter such as hair and dirt.

(4) Place the bag of silica gel in the case to avoid fogging. Only use

Olympus silica gel.

(5) Make sure that the TTL cable and hot shoe cable are connected firmly.

Q3 : What cautions must be observed when using and storing the Case?

A3 : Pay special attention to the following items.

(1) When the O-ring contact surface is pressed strongly from the outside of

the Case, or when the Case is twisted, the waterproof function may be

impaired and water leakage may be caused.

(2) When the Case is used, left or stored at the following locations, defective

operation or trouble may be caused. Always avoid such locations.

(a) Places where the Case can reach high temperatures under direct

sunlight or in a car, places with extremely low temperatures, and

places with extreme temperature variations.

(b) Places with open fire

(d) Places with vibrations

(3) The following instances could lead to operational problems and/or

damage to this case and the flash inserted in it. Avoid knocks and

sudden increase in pressure caused by:

(a) Hitting other objects

(b) Dropping

(4) When the Case is not used for a long time, trouble from formation of

mold etc. may be caused. Before use, confirm the operation of all

E-29