Olympus PT 021 Manual de instrucciones - Página 28
Navegue en línea o descargue pdf Manual de instrucciones para Accesorios para cámaras Olympus PT 021. Olympus PT 021 38 páginas. For the digital camera camedia x-350
Imprimir páginaCAUTION
: • When a mechanical pencil or a similar other sharp
object is used to remove the O-ring or to clean the
inside of the O-ring groove, the Case and the O-ring
may be damaged and water leakage may be caused.
• When the O-ring is checked with the fingertips, take
care not to stretch the O-ring.
• Never use alcohol, thinner, benzene or similar
solvents or chemical detergents to clean the O-ring.
When such chemicals are used, it is to be feared that
the O-ring will be damaged or that its deterioration will
be accelerated.
Install the O-ring.
Confirm that no foreign matter is attached, apply a thin coat of the
accessory grease to the O-ring, and fit the O-ring into the groove. At
this time, confirm that the O-ring does not stick out from the groove.
How to Apply Grease to the O-ring
Apply the
exclusive
1
lubricant to each
O-ring.
Spread the
2
lubricant all over
the O-ring.
Check that the
O-ring is free of
3
scratch or
unevenness.
Apply lubricant on
4
the O-ring contact
surface.
Make sure that your fingers and the O-
ring are free of dirt, and squeeze about
5 mm of lubricant onto a finger. (5 mm
is the most appropriate amount.)
Surround the lubricant with three
fingers and spread it over the ring. Be
careful not to use excessive force as
this may stretch the O-ring.
After spreading the lubricant, check
visually and by touch that the O-ring is not
scratched and that its surface is flat. If it is
damaged in any way, replace it with a
brand-new O-ring.
Use the lubricant remaining on the
fingers to clean and lubricate the
case's contact surface.
E-27