Olympus BH-NRE Manual - Página 11
Navegue en línea o descargue pdf Manual para Equipos de laboratorio Olympus BH-NRE. Olympus BH-NRE 17 páginas. Modular revolving nosepiece
Imprimir página
Figure 28 – Thoroughly remove any grease squeeze-out
Apply Grease to the Center-Pivot Bore
Apply a small amount of grease (item S1 of
into the center-pivot bore of the stationary base for the
¼" bearing ball (see
Figure
Figure 29 – Apply grease to the center-pivot bore
Reinstall the Center-Pivot Bearing Ball
Now that the center-pivot bore has been greased,
reinstall the ¼" bearing ball into the freshly greased
center-pivot bore. The grease will hold the center-pivot
bearing ball in the proper position during subsequent
reinstallation of the pivot-adjustment screw (see
30).
Figure 30 – Place bearing ball into the center-pivot bore
Complete Teardown, Cleaning, and Reassembly of the Olympus BH-NRE Modular Revolving Nosepiece
Appendix
29).
Figure
Apply Grease to Top of the Center-Pivot Ball
Apply a small amount of grease (item S1 of
onto the top of the ¼" bearing ball in the center-pivot
bore (see
Figure
2)
Figure 31 – Apply grease to the top of the bearing ball
Reinstall the Pivot-Adjustment Screw
Use a suitable slotted screwdriver to reinstall the pivot-
adjustment screw into the threaded bore in the center
of the stationary base (see
the adjustment screw just to the point where a slight bit
of resistance is felt. Leave the screw in this position and
test the feel of the revolving turret. If the motion feels
stiff, rough, or gritty, back the pivot-adjustment screw
off a bit until it feels smooth.
adjustment screw in this position.
Figure 32 – Reinstall the pivot-adjustment screw
Reinstall the Slotted Lock Ring
While being careful to not allow the pivot-adjustment
screw to rotate from the preset position set in the step
above, engage the threads of the slotted lock ring with
the threads of the pivot-adjustment screw (see
33).
31).
Figure
32). Carefully snug
Leave the pivot--
Appendix
2)
Figure
Page 11 of 17
Revision 3