Axminster 107699 Manual de instrucciones original - Página 6

Navegue en línea o descargue pdf Manual de instrucciones original para Torno Axminster 107699. Axminster 107699 17 páginas. Woodturning lathe

ASSEMBLY

Fig 04

Pre-drilled hole

Fig 05

ILLUSTRATION AND PARTS DESCRIPTION

Tailstock barrel adjusting grub

screws, to take up any play in the

barrel.

Mounting the Faceplate

If you are intending to use the 80mm faceplate (B) you

will need to remove the four prong drive centre (F) from

the headstock. Locate the push rod (H), insert it through

the headstock spindle to remove the drive centre, see

fig 04.

Insert the push rod (H) into one of the pre-drilled holes

on the headstock spindle. Screw the face plate onto the

spindle thread, place a spanner (I) over the faceplate

boss and while holding the push rod, rotate the spanner

clockwise to nip-up the face plate, see fig 05-06

Faceplate boss

Motor plate clamping bolt, loosen

& press down motor assembly to

increase tension to the belt then

retighten.

Control box - On/Off switch (A),

power LED light (B), speed control

dial (C) and power switch (D)

Fig 06

Loosen

Tighten