Axminster AWDTJ Manual - Página 2

Navegue en línea o descargue pdf Manual para Herramienta eléctrica Axminster AWDTJ. Axminster AWDTJ 6 páginas. 12" dovetail jig

Imprimir página
Index of Contents

What's in the Box...................................................................................................................................2

Illustration and Parts Description of Dovetail Jig/Fig 1................................................................................3
Introduction................................................................................................................................................... 3
Specification/Assembling and Mounting the Jig/
Preparation of Timber/Fig 2.......................................................................................................................... 4
Setting the End Stops/Fig 3.......................................................................................................................5/6
Setting Template Backstop/Fig 5............................................................................................................... 6/7
Assembling Timber into the Jig/Fig 6...........................................................................................................8
Setting the Dovetail Cutter/Fig 7...................................................................................................................9
Cutting the Joint................................................................................................................................ 10
Box Jointing/Figs 8 & 9...........................................................................................................................10/11
What's in the Box?
Part No
Item
1
Template
2
Eccentric Bar
3
Template Securing Screw
4
Template Adjusting Screw
5
Eccentric Bar Handle
7
Clamp Adjusting Screw
8
Eccentric Cam
9
Backstop Adjusting Screw
10
Top Clamp Bar
11
Front Clamp Bar
13
Long Stop Pin
13A
Short Stop Pin
14
Eccentric Bar Mounting
16
Clamp Bar Spring
17
Main Body
22
Backstop
24
TCT Router Cutter (P217011)
02
Page No.
The first board should be positioned in the jig with its left hand edge in line with the left hand
edge of one of the template fingers and its top edge in contact with the underside of the template
as shown in Fig 9. Place the router on the template with the cutter clear of the timber, start up the
router and then trace around the template fingers. When cutting is completed switch off the
router and let it come to a stop before removing from the jig.
The second board is cut in the same way except that its left hand edge is lined up with the right
hand edge of one of the template fingers; this will automatically produce the necessary 1/2"
offset between the two halves of the joint.
Qty
If multiple joints are to be made then it may be more convenient to use the vertical end stop to
position the timber correctly relative to the template quickly and accurately each time.
1
WARNING Before starting to cut the timber make sure that (a) the bottom of the cutter is
2
well clear of the top face of the body of the jig and (b) the cutter guide bearing is running
4
correctly in the template.
2
2
4
4
2
1
1
2
2
4
4
1
There is a special kit available, consisting of fine finger template, template guide and cutter,
1
which can produce 6mm deep dovetails spaced 11mm apart for making small boxes, drawers,
jewellery boxes and similar small projects. There is also a fine comb jointing cutter for use with
1
the same template.
(Order from Axminster Power Tool Centre under the following numbers):
DTJFDS Fine Dovetail Set
SFJC
Fig 8
Fig 9
Fine Comb Joint Cutter
8. Box Jointing Continued
Align one board with
left hand edge of finger,
the other with right
hand edge.
Miniature Joints
11