Axminster Craft 105110 Manual de instrucciones original - Página 12

Navegue en línea o descargue pdf Manual de instrucciones original para Sander Axminster Craft 105110. Axminster Craft 105110 17 páginas. 300mm

Changing the Sanding Disc

DISCONNECT THE MACHINE FROM THE MAINS SUPPLY!

1. Remove the sanding disc guard by removing

the two Phillips screws on top of the guard.

2. Remove the two locking handles on either

side of the sander.

3. Remove the swivel studs and lift the table

away.

4. Lift the edge of the disc and, gripping firmly,

peel the disc away from the plate; turning the

plate as required to free the entire disc.

5. Remove and throw away. If you have been

extremely fortunate all the adhesive will have

been removed with the disc. As this is rarely

the case, be prepared to rub, scrape, pick etc.,

DISCONNECT THE MACHINE FROM THE MAINS SUPPLY!

There is very little mechanical maintenance that can be carried out on the machine. Most

prudent maintenance is preventative and concerned with keeping the machine clean.

Inspect and remove all dust/resin build ups, and blow the motor clean.

Remove the sanding disc guard, remove any build ups and clean them thoroughly to allow the

dust to travel over their surfaces smoothly.

6. Clean the surface of the disc with a

degreasing cleaner, (methylated spirit;

acetone nail polish remover borrowed from

the female side of the family, if you don't have

a proprietary cleaner.) Allow to dry off and wipe

over with a clean dry cloth. Locate the sanding

disc, peel the cover from the adhesive surface

and apply CAREFULLY to the disc.Use a piece

of cloth in your hand or wear a glove, to firmly

press the abrasive to the disc, the application

will be reinforced by a gentle sanding action

across the face when you first use the new

sanding disc.

7. Replace the table and guard as described

above, in reverse and continue operation.