Axminster Trade 101701 Manual de instrucciones original - Página 2

Navegue en línea o descargue pdf Manual de instrucciones original para Sander Axminster Trade 101701. Axminster Trade 101701 18 páginas.

Warnings

1. Read and understand the entire owner's manual before attempting assembly or operation.

2. Read and understand the warnings posted on the machine and in this manual. Failure to comply with

all of these warnings may cause serious injury.

3. Replace the warning labels if they become obscured or removed.

4. This Oscillating Edge Sander is designed and intended for use by properly trained and experienced

personnel only. If you are not familiar with the proper and safe operation of an edge sander, do not

use until proper training and knowledge have been obtained.

5. Do not use this machine for other than its intended use.

6. Always wear approved safety glasses/face shields while using this Oscillating Edge Sander.

Everyday eyeglasses only have impact resistant lenses; they are not safety glasses.

7. Before operating this edge sander, remove tie, rings, watches and other jewelry, and roll sleeves up

past the elbows. Remove all loose clothing and confine long hair. Non-slip footwear or anti-skid floor

strips are recommended. Do not wear gloves.

8. Wear ear protectors (plugs or muffs) during extended periods of operation.

9. Some dust created by power sanding, sawing, grinding, drilling and other construction activities

contain chemicals known to cause cancer, birth defects or other reproductive harm. Some examples

of these chemicals are:

•

Lead from lead based paint.

•

Crystalline silica from bricks, cement and other masonry products.

•

Arsenic and chromium from chemically treated lumber.

Your risk of exposure varies, depending on how often you do this type of work. To reduce your

exposure to these chemicals, work in a well-ventilated area and work with approved safety

equipment, such as face or dust masks that are specifically designed to filter out microscopic

particles.

10. Do not operate this machine while tired or under the influence of drugs, alcohol or any medication.

11. Make certain the switch is in the OFF position before connecting the machine to the power source.

12. Make certain the machine is properly grounded.

13. Make all machine adjustments or maintenance with the machine unplugged from the power source.

14. Form a habit of checking to see that all extra equipment such as adjusting keys, wrenches, scrap,

stock, and cleaning rags are removed away from the machine before turning on.

15. Keep safety guards in place at all times when the machine is in use. If removed for maintenance

purposes, use extreme caution and replace the guards immediately when maintenance is complete.

16. Make sure the edge sander is firmly secured to the floor before use.

17. Check damaged parts. Before further use of the machine, a guard or other part that is damaged

should be carefully checked to determine that it will operate properly and perform its intended

function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting

and any other conditions that may affect its operation. A guard or other part that is damaged should

be properly repaired or replaced.

18. Provide for adequate space surrounding work area and non-glare, overhead lighting.

19. Keep the floor around the machine clean and free of scrap material, oil and grease.