Alphasmart AS 2000 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Software Alphasmart AS 2000. Alphasmart AS 2000 6 páginas. For pc
También para Alphasmart AS 2000: Manual (5 páginas)

Imprimir página

Infrared troubleshooting for AlphaBeam

This section describes special steps for those using a serial IR pod on Windows 95, 98, NT, 2000,

or XP. (Windows Me is not compatible with the serial IR pod.)

Test circle testing my COM port doesn't turn red.

If you chose a typical installation with the serial IR pod, the installer shows you a test screen for

testing your COM port. If, after following the steps on the test screen, you can't get the test circle

to turn red, try these steps:

•

Press

on the AlphaSmart device, rather than

•

Test all the COM ports that are available in the list. If none of them work and you have more

than one physical COM port, try plugging the serial IR pod into another COM port connector

and testing all the ports in the list. (Usually, the pod will work with one of the first four COM

ports in the list.)

When you select a different COM port from the list, make sure you exit from Print mode on

the AlphaSmart device and then press

If you chose a custom installation with the serial IR pod, the installer asks you to choose the

correct manufacturer and model of the infrared device. Make sure you choose ACTiSYS as the

manufacturer and ACT-IR220L as the model number.

After installing AlphaBeam, you need to restart the computer. Once the computer restarts,

choose Start > Programs > AlphaSmart > AlphaSmart IR Setup to select and test the correct COM

port before using AlphaBeam.

041014

send

again.