Accuphase AD-2800 Manual de instrucciones - Página 2
Navegue en línea o descargue pdf Manual de instrucciones para Ecualizador estéreo Accuphase AD-2800. Accuphase AD-2800 2 páginas. Phono equalizer unit
Imprimir página
Thank you for purchasing the Phono Equalizer Unit AD-2800.
This unit is designed for installation in the preamplifier models listed below, to provide
analog disc reproduction capability. After installation, all functions are operated with
the controls on the front panel of the preamplifier. For details about use, please refer to
the instruction manual of the preamplifier in which the unit is installed.
＊ Supported models : C-2810, C-2800, C-2400
＊ Because the unit is compatible with the AD-290/AD-290V, it can also be used in the preamplifier
models C-290 and C-290V.
●
1
Set the power switch of the preamplifier to OFF.
●
2
Remove the sub panel of the expansion slot on
the rear panel. Use the supplied hex wrench to
remove the four screws by turning them coun-
terclockwise (see Fig. 1).
The removed sub panel is not used.
Expansion
slot
Guide rails
Sub panel
CAUTION
Be sure to set the power switch of the preamplifier to OFF before inserting or
●
removing the AD-2800. Otherwise damage may occur.
Do not touch the component side, solder side, or connector of the AD-2800.
●
Otherwise static discharge may cause damage, and contact problems may occur.
Make sure that all four screws of the are securely fastened. Otherwise a floating
●
ground condition may occur, which can lead to damage.
2-14-10, SHIN-ISHIKAWA, AOBA-KU, YOKOHAMA 225-8508, JAPAN
F061.5X
PHONO EQUALIZER UNIT
AD-2800
Installation
Hex wrench
Fig. 1
ACCUPHASE LABORATORY, INC.
Instruction Manual
●
Slide the AD-2800 into the preamplifier along the
3
two guide rails on both sides (see Fig. 2). When
you feel a certain resistance, give the AD-2800 a
slight push until the connector is fully plugged
in. When the AD-2800 is flush with the rear panel,
it is inserted correctly.
●
4
Use the four screws to fasten the AD-2800 by
turning the screws clockwise.
Phono Equalizer Unit
AD-2800
Fig. 2
820-3212-10(K6) Printed in Japan