AccuPulse NIBP Simulator Manuales de funcionamiento - Página 20

Navegue en línea o descargue pdf Manuales de funcionamiento para Equipos de prueba AccuPulse NIBP Simulator. AccuPulse NIBP Simulator 20 páginas. Hand held nibp simulator

Imprimir página
Commonly Used Remote Control Commands Short Listing
<>
(Initiates the communication, wake simulator comm port)
<KEYPAD_OFF>
(locks out front panel keypad use)
<KEYPAD_ON>
(enables it again)
General Buttons
These button commands operate throughout all modes.
<BUTTON>
BP
<BUTTON>
LEAK
<BUTTON>
OVERP
<BUTTON>
METER
<BUTTON>
MENU
<BUTTON>
F1
<BUTTON>
F2
<BUTTON>
F3
<BUTTON>
F4
<BUTTON>
UP
<BUTTON>
DWN
<BUTTON>
LEFT
<BUTTON>
RIGHT
There are 2 direct commands to read the manometer
<MAN_STR>
[ON/OFF]
<MAN_SMP>
The following bypass some button sequences and set operating parameters
with direct commands. These should produce cleaner final coded command
sequences and reduce effort for the most often changed settings.
Variations for alternate keypads
Generic Keypad
ESC
SCROLL_UP
SCROLL_DOWN
ENTER
( Continuously stream readings )
( Single reading sample )
BP Test Settings
<GET_BP_PARAMS>
<SET_PRESET>
1,1
<SET_PRESET>
0,6
Bench Top Unit
<SET_PR>
123
PREV
<SET_AMP>
99
NEXT
<SET_SHFT>
-30
<SET_SHFT>
50
The following are less often changed operating parameters. Some are only
available if the option is loaded.
BP Test Configuration Settings
<SET_BP_MODE>
BP_PRESET
loaded)
<SET_CALTABLE>
5
<SET_CALTABLE>
46
)
<SET_UTP>
32
Special Commands not typically needed
<GET_SERIAL_NUM>
<I>
<GET_DEVICE_ID>
<SET_DEVICE_ID>
CDCT #1
20
(unit answers with it's current settings)
( 1,1 is ADULT, preset#1 = typically 60/30 )
(ADULT presets are 1-7)
( 0,6 is NEO, preset#6 = typically 150/120 )
(NEO presets are 1-6)
( Pulse Rate = 123 Range 15-330 )
( Amplitude = 99
Range 0-150% )
( most users should leave this at default of 100%)
( shift preset by Negative 30 mmHg )
( shift preset by Positive 50 mmHg )
( Shift range -50 to 100 mmHg, OR, instrument
Max/Min limits)
*OPTION*
(or UTP_MODE if optional User Defined mode was
*OPTION*
( digit 1-45 , only populated slots can be selected )
( 46 = Generic, it is the default included in all units
*OPTION*
( digit 1-45 )
(returns the unit Serial Number)
(returns the Software version)
(returns USB/FTDI ID if set, or if not set "* " )
(sets USB/FTDI ID to " CDCT #1 ")