ARC MYCR-250 Manual - Página 8

Navegue en línea o descargue pdf Manual para Accesorios ARC MYCR-250. ARC MYCR-250 12 páginas. Wireless mini dimmer socket switch plug

Issue Date: 05/02/2020

4. Trailing & Leading Edge Setup

Initial factory pre-set is at 'Leading Edge'.

Depending on the load you are using, please use the appropriate setting.

To change between Leading edge and Trailing edge, please follow below setup.

Leading Edge to Trailing Edge

1. Load must be at 'ON' status.

2. Press and hold down 'ON/OFF' button for 10 seconds.

3. LED on socket switch will flash 4 times each interval.

4. Press 'ON/OFF' button again to switch from Leading edge to Trailing edge.

5. LED on socket switch will quick flash and load will flash twice and resume to

the lowest dim level to confirm Trailing Edge setup is complete.

6. After the setup is completed, each time you operate ON/OFF under Trailing

Edge the LED on socket switch will flash twice.

Trailing Edge to Leading Edge

1. Load must be at 'ON' status.

2. Press and hold down 'ON/OFF' button for 10 seconds.

3. LED on socket switch will flash 4 times each interval.

4. Press 'ON/OFF' button again to switch from Trailing edge to Leading edge.

5. LED on socket switch will quick flash and load will flash twice and resume to

the lowest dim level to confirm Leading Edge setup is complete.

6. After the setup is completed, each time you operate ON/OFF under Leading

Edge the LED on socket switch will flash once.

TRAILING & LEADING EDEGE SETUP