ACCUR8 YD8266WUK-BL Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Estación meteorológica ACCUR8 YD8266WUK-BL. ACCUR8 YD8266WUK-BL 8 páginas. Weather forecast station

Imprimir página
Radio-controlled Time Reception
1. RCC reception is initiated when the display console is powered up
2. To manually start RCC reception; in Setting mode, press and hold the DOWN button to start
searching for the radio-controlled time signal.
Important notes:
•
It can help to place the display console near an open window while it is searching for the radio-
controlled time signal
•
When searching for the radio-controlled time signal, the display screen will be dimmed
•
If the display console will still not receive the RCC signal, please proceed to set the time manually.
Manual Time Setting
1.
In Normal mode, press MODE for three seconds to enter the Time Setting mode.
2.
Setting order: hour > minute > year > month > day > 12 / 24hr > exit
3.
Press MODE to confirm the setting result and move to the next setting item
4.
Press UP to increase the value by one unit; press and hold UP for more than two seconds to
advance at eight steps per second
5.
Press DOWN, to decrease the value by one unit; press and hold DOWN for more than two seconds
decrease eight steps per second
No changes to settings within 20 seconds will save the settings and exit.
Alarm Setting
1.
In the standard mode, press the MODE button to view the alarm time, press the UP or DOWN switch
on/off the Alarm
2.
In Alarm mode, press MODE button for three seconds to enter Alarm setting mode
3.
Setting order: hour > minute > exit
4.
In the setting, press UP and DOWN to adjust the setting item, press SET to confirm
5.
Alarm ringing time is two minutes
6.
When the alarm is on, press SNZ / LIGHT to delay the alarm for five minutes. To stop the alarm,
press any other button.
°C/°F selection
Press UP button to select
Viewing Maximum and Minimum Recorded Values
Press MEM to view the maximum and minimum temperature and humidity values recorded.
In maximum and minimum modes, press and hold for three seconds to clear the maximum and minimum
values.
Day of Week Display
Receiving the Remote Sensor (RF) Signals
1.
When powered on, the display automatically seeks to receive the RF signal for three minutes, and
the antenna icon will flash.
2.
Once the signal is received, the display will receive the outdoor temperature and humidity at the
same time.
3.
In standard mode, press CH once to change RF channel.
4.
Press and hold CH to re-register RF data for all channels
5.
In the case of RF registration failure or missing code time for more than one hour, the temperature
and humidity section will flash "--.-".
6.
To manually initiate a remote sensor search, press and hold CH.
4