ARC Audio XDi 650.1 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Amplificador ARC Audio XDi 650.1. ARC Audio XDi 650.1 11 páginas. Full range class d amplifier

ARC Audio XDi 650.1 Manual del usuario
Strapping
Strapping is the same thing as Bridging but refers to using 2 amplifiers This is a way of combining the power of 2 channels into 1.
When you wire the amp bridged you have a higher voltage differential between + and -. That means MORE POWER. If you have 2
identical, properly designed mono amplifiers (They can not be a stereo amp that is bridged internally) you can bridge them together
to create 1 channel.
Set to
NORMAL
Set to
SLAVE
Warning
When bridging any amp or amps, each channel sees half the Ohm load. 4 ohms bridged is the same as 2 Ohms stereo. 1 ohm bridged is equal
to 1/2 ohm stereo. Check the compatibility of you woofers and amplifier before you begin.
2 KS XDi 650. 1 or XDi 1100. 1 s in a bridged configuration must not be connected to a load lower then 2 Ohms.
XDi 650. 1
XDi 1100. 1
STRAPPING
Can be set to
IN or OUT But
The PHASE Settings
MUST be OPPOSITE
From Head Unit
OPPOSITE
The "MASTER"
Setting
For strapping to work both amplifiers must be playing exactly the
same signal at exactly the same output level. To make this easier
use the "MASTER" and "SLAVE" but the slave amp must be set
"Out of PHASE" to the Master.
Use the configuration below.
WARNING:!
This is not a typo. You must
use both Positives (+) to drive
the woofer. The Negatives (-)
of both amplifiers must be
tied together. Failure to follow
this procedure exactly could
lead to amplifier failure.
7
+
2200W@
2 Ω
-