Accurate Technology DigiStop-10 Manual de instalación y funcionamiento - Página 11
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Instrumentos de medida Accurate Technology DigiStop-10. Accurate Technology DigiStop-10 20 páginas. Digi-stop series
additional 1/64 of an inch measurement making the true, full resolution
measurement 2 13/64ths.
Some users find this resolution unnecessary and prefer the 16ths or 32nds
mode instead. For better resolution, switch to 64ths mode. For the best
resolution switch to a decimal mode – inches or millimeters..
When the measurement is greater than 99 63/64 inches, a +100 and/or +200
will illuminate in the upper right portion of the display to indicate this amount
must be added to the displayed reading. For example; the LCD pictured above
right is indicating a measurement of 151 39/64 inches. If the measurement was
351 39/64 inches, the +100 and +200 will be illuminated on the display.
+,
, and -
DATUM
The
+
(plus),
DATUM
displayed position to a different value. The
user programmed value.
Momentarily depressing the
(fractions, decimal or mm depending on the current mode selected by the
key) of measurement. Momentarily depressing the
UNITS
the current reading by one unit. Pressing and holding the
the displayed reading to change continuously. Holding down the key will cause
the amount of change to speed up. This allows for quick adjustments over a
range of large values.
NOTE: While the
displayed reading, it can also be programmed to force the readout to a preset
value. This can be zero, or any other displayable value.
See Section 3: Readout Programming,
Reverse the Measurement Readings
Reverse the readings means changing the direction of measurement produced
by movement. If the Digi-Fence decrements (reduces or goes negative) when it
should be incrementing (increasing or going positive), the readout will need to
be re-programmed for your installation.
See Section 3: Readout Programming,
Accurate Technology Digi-Stop
–
and
(minus) keys are used to change the currently
Programming Parameter Pr1
+
key increments the current reading by one unit
key can be used to simply "zero" the currently
DATUM
key forces the readout to a
DATUM
Programming Parameter Pr1.
Programming Parameter Pr2.
(default is zero 0.00)
–
key decrements
–
+
or
keys will cause
Page 11 of 20