Arcam FMJ A32 Manual - Página 10

Navegue en línea o descargue pdf Manual para Amplificador Arcam FMJ A32. Arcam FMJ A32 16 páginas. Amplifiers
También para Arcam FMJ A32: Manual de servicio (18 páginas)

Imprimir página

Using the remote control

CR-389 REMOTE CONTROL

The CR-389 remote control gives access to all functions available on

the front panel of the A32. It also has controls to operate Arcam CD

players, AM/FM tuners and DAB tuners. The remote control transmits

Philips RC-5 type codes.

TUNER

These buttons are used to control tuner functions.

Note that the

FM/DAB

lights indicate into which mode

you are switching the remote control. The lights only

illuminate for five seconds to conserve battery power.

If neither light is illuminated this does not mean that the remote

control is not working!

(UP and DOWN)

Perform the same function as the

panel (see page 6).

ENTER

Performs the same function as the

ENTER

panel (see page 8).

SELECT

Performs same function as the

SELECT

panel. It allows you to use the remote's volume switch in the

same way you use the control dial on the front panel – to

adjust various amplifier settings (see page 8).

Note that pressing + corresponds to turning the

Control knob clockwise, – to anticlockwise.

Source selection buttons

These operate in the same way as the source selectors on the

front panel of your integrated amplifier.

DAB

1- 9

5- 1 3

buttons on the front

MODE

ENTER

button on the front

PHONO

A V

TUNER

DAB

Power/Standby

Toggles the amplifier between standby mode and full power

mode. The power indicator light next to the power button on

DISP

the front panel is red if the amplifier is in standby, amber while

the amplifier is powering up (this only takes a few seconds) and

2- 1 0

3- 1 1

4- 1 2

green when the amplifier is powered up.

6- 1 4

7- 1 5

8- 1 6

SP1 and SP2

BAND

These buttons allow you to select and deselect the main (SP1)

and secondary (SP2) sets of speakers attached to your amplifier

SP1

(see page 6).

SP2

DISP

DISP (display)

SEL

Cycles through the settings 'Bright', 'Off ' and 'Dim'. Turning the

display 'Off ' generally gives a slight improvement in sound quality.

Volume and

Press

of the amplifier.

Press

AUX

TUNER

Both tape outputs and the headphone socket remain active.

Mute is disabled either by pressing

DVD

VCR

TAPE

the volume.

You can use the remote's volume control in conjunction with

AMPLIFIER

the

RPT

PROG

DISP

CD controls

These offer basic control of Arcam CD players

CR-389

NOTE

Remember to install the two AAA batteries supplied

before trying to use your remote control.

Do not place anything in front of the FMJ badge on

the top left of the CD player (where the IR receiver

is located), or the remote control may not work.

(mute)

to increase volume or

–

to decrease the output volume

to mute the speaker connections and preamp outputs.

again, or by adjusting

SELECT

button to adjust balance, tone and amplifier settings.