Arcam P38 Manual - Página 9

Navegue en línea o descargue pdf Manual para Amplificador Arcam P38. Arcam P38 18 páginas. Integrated and power amplifiers
También para Arcam P38: Manual (18 páginas)

Imprimir página

Using the remote control

CR-389 Remote Control

The CR-389 remote control gives access to all functions

available on the front panel of the C31. It also has

controls to operate Arcam CD players and tuners.

TUNER

These buttons are used to control Arcam tuner

functions.

Note that the

lights indicate into which

FM/DAB

mode you are switching the remote control. The

lights only illuminate for fi ve seconds to conserve

battery power.

If neither light is illuminated this does not mean

that the remote control is not working.

* +

(UP and DOWN)

These buttons are used in the confi guration menu

and have the same effect as turning the control

knob. Pressing

is the same as turning the

control knob clockwise,

is the same as turning

the knob anticlockwise.

ENTER

Performs the same function as the

on the front panel (see page 8).

SEL (Select)

Performs same function as the

the front panel. It allows you to use the remote's

volume switch in the same way you use the

control dial on the front panel – to adjust various

amplifi er settings (see page 8).

Pressing

corresponds to turning the control knob

clockwise,

to anticlockwise.

–

Source selection buttons

These operate in the same way as the source

selectors on the front panel of your C31.

NOTE: Remember to install the two AAA batteries

supplied before trying to use your remote control.

Do not place anything in front of the FMJ badge on

the top left of the C31 (where the IR receiver is

located), or the remote control may not work.

button

ENTER

button on

SELECT

TUNER

DAB

DISP

DAB

1- 9

2- 1 0

3- 1 1

4- 1 2

5- 1 3

6- 1 4

7- 1 5

8- 1 6

MODE

BAND

SP1

SP2

ENTER

DISP

SEL

PHONO

AUX

TUNER

A V

DVD

VCR

TAPE

AMPLIFIER

RPT

PROG

DISP

CR-389

Power/Stand-by

Toggles the C31 between stand-by mode and full

power mode. The power indicator light on the front

panel is red if the C31 is in stand-by, amber while

it is powering-up (this takes only a few seconds)

and green when the C31 is operational.

SP1 and SP2

These buttons are for use with the P35 amplifi er,

to allow you to select and deselect the main (

and secondary (

) sets of speakers attached to

SP2

it (see page 14 for further information).

DISP (display)

Cycles through the settings 'Off', 'Dimmed' and

'Bright'. Turning the display 'Off' may give a slight

improvement in sound quality.

Volume and

(mute)

Press

to increase volume or

–

output volume of the amplifi er.

Press

to mute the pre-amp outputs of the

C31. Note that both recording outputs will remain

active. Mute is disabled by either pressing

again, or adjusting the volume.

CD controls

These offer basic control of Arcam CD players.

If you wish to use the same

remote control for both your C31

and your DT91 tuner, please use

the CR-389D remote control shipped

with the tuner (instead of the

remote control described here).

)

SP1

to decrease the

C31/P35/P1

E-9