Arcam P90 Manual - Página 14
Navegue en línea o descargue pdf Manual para Amplificador Arcam P90. Arcam P90 15 páginas.
Imprimir página
Service information
Before returning your amplifier for service, please check the
following:
Sound cuts out for no reason
If the temperature of the internal heatsink rises above a safe
level, then a thermal cutout inside the amplifier will operate.
The power indicator on the front panel flashes and the
protection system temporarily removes the power to the
speakers. The system resets itself as the heatsink cools down.
Technical specifications
Continuous power output, per channel
Both channels, 8Ω, 20Hz–20kHz
Single channel, 4Ω, 1kHz
Distortion, 8Ω, 80% power, 1kHz
Inputs
Phono cartridge (optional module)
Line and tape inputs
Tone controls, max. boost/cut
Preamplifier outputs
Nominal output level
Output impedance
General
Power consumption (maximum)
Dimensions W x D x H (including feet)
Weight (net)
Weight (packed)
Supplied accessories
E&OE
Continual improvement policy
Arcam has a policy of continual improvement for its products.
This means that designs and specifications are subject to
A90/P90
change without notice.
14
input sensitivity, MM
input sensitivity, MC
Nominal sensitivity
Input impedance
Signal/noise ratio (CCIR)
With two pairs of low impedance speakers connected,
overloads are more likely. Overloading the amplifier may
cause it to shut down because of overheating.
Note that because of the high output voltage from a CD
player, it is possible to drive the A90 at full power even
though the volume is not set at maximum.
Amplifier does not switch back on
The A90 and P90 amplifiers have a protection mechanism
which is activated if you switch the unit on immediately after
turning it off. If this mechanism activates, wait 30 seconds then
try again.
A90
90W
150W
0.005%
2.5mV
250µV
250mV
22kΩ
105dB
±12dB
700mV
<50Ω
800VA
435 x 340 x 100mm
9kg
10.5kg
mains lead
CR-389 remote control
2 x AAA batteries
NOTE: All specification values are typical unless otherwise
stated.
P90
90W
150W
0.005%
700mV
22kΩ
112dB
800VA (950VA for P90/3)
435 x 320 x 100mm
9.5kg (10.5kg for P90/3)
11kg (12kg for P90/3)
mains lead