Arcam irDAC-II Conexiones y manual de inicio rápido - Página 17

Navegue en línea o descargue pdf Conexiones y manual de inicio rápido para Media Converter Arcam irDAC-II. Arcam irDAC-II 19 páginas.

Imprimir página

FCC INFORMATION (FOR US CUSTOMERS)

PRODUCT

This product complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTICE: DO NOT MODIFY THIS PRODUCT

This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modification not expressly approved by

ARCAM may void your authority, granted by the FCC, to use the product.

NOTE

This product has been tested and found to comply with the limits for a Class B digital device, persuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential installation.

This product generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this product does

cause harmful interference to radio or television reception, which can be determined by turning the product OFF and ON, the user is encouraged to try

to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the product into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the local retailer authorized to distribute this type of product or an experienced radio/TV technician for help.

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and

operated with minimum distance 20 cm between the antenna and your body.

INDUSTRY CANADA INFORMATION (FOR CANADIAN CUSTOMERS)

This Class B digital apparatus complies with canadian ICES-003

"This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device

may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the

device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée

aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement"

"This radio transmitter 10792A – DNW101025 has been approved by Industry Canada to operate with the antenna types listed below with the

maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a

gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.

Le présent émetteur radio 10792A – DNW101025 a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés

ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne. Les types d'antenne non inclus dans cette

liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur. "

Wanshih WSS002, Antenna Gain +2dBi

"This equipment complies with IC RSS102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed

and operated with minimum distance 20 cm between the antenna and your body.

Cet équipement est conforme aux limites IC RSS102 d'exposition aux rayonnements définies pour un environnement non contrôlé. Cet

équipement doit être installé et utilisé à distance minimale de 20 cm entre l'antenne et votre corps. "

IMPORTANT ANTENNA INFORMATION

The irDAC-II is only designed to operate with the supplied antenna. Any other antenna is strictly prohibited for use with the irDAC-II.