Circe Cycles Helios Manual de montaje - Página 5

Navegue en línea o descargue pdf Manual de montaje para Bicicleta Circe Cycles Helios. Circe Cycles Helios 8 páginas. Separable tandem
También para Circe Cycles Helios: Manual del usuario (12 páginas), Manual del usuario (15 páginas)

Imprimir página

INSTALLING STOKER STEM AND HANDLEBAR

For packing, the seat posts come fitted in the

opposite positions. i.e. the Stoker seat post is in the

Captain's position and vice versa.

STOKER

The Captain's seat post is in one piece and this

is the post the stoker stem and handlebar should

be fitted to. The telescopic two-piece post is the

Stoker's and should be fitted to the rear position.

INSTALLING THE PEDALS

(Your own if not ordered from us) – The pedal

threads are handed. The right hand pedal tightens

in the normal direction; the left-hand pedal has

a left-hand thread, and tightens in the opposite

direction to normal. Tighten the pedals to the

torque shown in Appendix A.

BELL AND REFLECTORS

Reflectors and a bell are supplied with your

tandem. The bell can be mounted anywhere on

the handlebars where it can be reached easily.

The front reflector can also be attached to the

handlebar. The rear reflector fits to the Stoker

seatpost, ensure that the reflector is visible at the

height you intend to have the post at. If not, you

may need to reposition the reflector so that it is

visible.

CAPTAIN

CirceCycles.com

PRE-RIDE

Check all nuts, bolts and quick releases to make

sure everything is tight (See appendix A for torque

settings). Ensure the wheels spin freely and the

brakes function correctly.

FIRST RIDE

Check the gears shift correctly, refer to the Owner's

manual, or manufacturers manual, for adjustment.

Pay attention to the fit and make any adjustments

required, once you are stationary. Finally, ensure

there are no rattles or unexpected sounds.

You can now refer to the User's manual for final

set up and on-going maintenance, or continue

reading if you have a Triplet.

INSTALLING THE TRIPLET MODULE

The Triplet comes assembled as a tandem with the

Triplet section removed. First the tandem needs to

be separated (refer to the Separable manual for

doing this).

NOTE - For STEPS, the electrical cables will need to

be detached first. Locate the cables at the base of

the stoker seatpost, remove the plastic bung and

then gently pull the cables out until the junctions

are exposed, then use the Di2 tool to separate

them.

NOTE - Only detach the end of the junction that

isn't heat shrinked.

Once the tandem is separated, you can then

attach the Triplet module. If you have a STEPS

equipped tandem, you will first need to thread the

electrical cables through the triplet main tube from

the front end, use the steel wire provided to pull the

cables through.