Axxera DA904 Manual de instalación y del usuario - Página 11

Navegue en línea o descargue pdf Manual de instalación y del usuario para Amplificador Axxera DA904. Axxera DA904 17 páginas. Power series mobile power amplifiers

Imprimir página

INSTALLATION

Connecting Two Amplifiers - Bridge Mode

Master/Slave Mode (cont.)

*MASTER

For master amplifier, set the switch to master. This will route the signal through Line-out to

the slave amplifier. Set the phase to 0, all adjustments for gain and sound are done on this

amplifier. The remote subwoofer control should be connected to master amplifier as well.

*SLAVE

For slave amplifier, set the switch to slave and phase to 180. Connect the Line-out of master

amplifier to input on this amplifier. All adjustments should be set to minimum.

Connect Data-Link plug from master to slave amplifier. For speaker connection, the positive

(+) of the speaker connects to positive (+) of master and negative (-) of the speaker connects to

positive (+) of slave amplifier. Connect both negatives (-) of master and slave each other.

NOTE: FOR BEST PERFORMANCE, USE WIRE 12 AWG OR THICKER FOR THE NEGATIVE TO

NEGATIVE CONNECTION.

*MINIMUM IMPEDANCE MUST NOT BE LOWER THAN 2 OHMS