digico SD10 Manual - Página 7

Navegue en línea o descargue pdf Manual para Equipos de grabación digico SD10. digico SD10 9 páginas. Replacing and cleaning faders
También para digico SD10: Manual del usuario (20 páginas)

Imprimir página
digico SD10 Manual
Cleaning Faders - Follow steps 1 – 8 above
12. Use a clean paint brush and the vacuum cleaner to remove any loose dust and
dirt from the fader board, then use compressed air to dislodge any dust and dirt
from the inside of the fader assembly, then use the vacuum cleaner to remove
the dust and dirt. Repeat as necessary.
13. Lay the fader board on paper towels, place the thin nozzle applicator of the
degreaser along the fader track, give a quick spray and then move the fader up
and down.
14. Use the paper towel to clean up any excess mess, and use the compressed air to
dry the fader tracks.
15. Then spray some of the cleaner-lubricant spray (DeoxIT F5) along the fader slot and with the fader at
one end spray for no more than 1 second.
16. Move the fader up and down approximately 20 times and use the paper towel to wipe up any excess
or dirty liquid.
17. Repeat steps 11 - 13 for the remaining faders.
18. Re-install the faders, screw down the fader driver PCB, plug the faders
into the PCB, and carefully re-plug the connectors to the PCB's. Place
the fader panel back into the console, switch the console on and test
the functionality of the faders and buttons – the panel can now be
screwed back into place.
TN 559 – Cleaning and replacing faders - All consoles
Page 7