Axxess ASWC-1 Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Accesorios para automóviles Axxess ASWC-1. Axxess ASWC-1 6 páginas. Connections
También para Axxess ASWC-1: Instrucciones de instalación (4 páginas), Instrucciones (5 páginas)

Imprimir página

If for any reason after remapping the steering wheel controls you want to go

back to the original steering wheel control settings, follow these steps:

1) Within the first 20 seconds of turning the ignition on, press and hold down the original

"Volume Down" button (not the "Volume Down" button you just remapped) for at least

25 seconds.

2) The LED will light up solid, and then release the "Volume Down" button and the

LED will go out.

3) The original steering wheel control settings will be restored

Dual Assignment Instructions

Note: Seek up and Seek down are already set to Preset up and Preset down for

long press.

1) Turn on ignition but do not start the vehicle.

2) Turning the radio "OFF" is recommended.

3) Press and hold down the steering wheel button that you want to assign a long

press function to, for about 10 seconds until the LED rapidly flashes green. At this

point release the button and the LED will go solid green.

4) Press and release the "Volume up" button the number of times corresponding

to the new button number you selected (see chart). The green LED will blink

rapidly when the "Volume up" is pressed and back to solid green when it is

released.

(Caution, if more than 10 seconds elapses between a "Volume up" button presses,

this procedure will abort. And the LED will go off) Go to the next step when the

"Volume up" button has been pressed the necessary number of times.

5) To store the long press button in memory, press the button that you assigned a

long press button (the button held down in step 1). The LED will now go off

indicating it has been stored.

Note: These steps must be repeated for each button you would like to assign

dual purpose action to.