Axxess AXTC-VW1 Instrucciones de instalación - Página 3
Navegue en línea o descargue pdf Instrucciones de instalación para Equipos de grabación Axxess AXTC-VW1. Axxess AXTC-VW1 4 páginas. Volkswagen swc (steering wheelcontrol) and datainterface2002-2017
Imprimir página
1.
Open the driver's door, and keep open during the programming process.
2.
Cycle the ignition on.
3.
Connect the AXTC-VW1 harness to the AXTC-VW1 interface, and then to
the wiring harness in the vehicle.
4.
Tap Volume Up
Locate the Volume Up button on the the steering wheel. Program the
interface by tapping the Volume Up button at a heartbeat pace until the
VOL
+
LED light stops flashing.
5.
The LED light will flash Green & Red while the interface programs
the radio to the steering wheel controls. Once programmed, the
LED light will go out, then produce a pattern which will identify the
Green & Red LED
radio type installed. Refer to the Radio LED Feedback section under
Troubleshooting for radio types.
Green or Red LED
PROGRAMMING
6.
Green & Red LED
Green LED
7.
8.
The LED light will go out, then once again quickly flash Green & Red
while the interface programs itself to the vehicle. Once programmed,
the LED light will go out again, then turn solid Green.
Cycle the ignition off, then back on.
Test all functions of the installation for proper operation.
Note: Audio Mode must be selected in the MFI menu to allow track up
and down to function. Refer to the vehicle owner's manual for more
information.
REV. 7/30/2019 INSTAXTC-VW1
3