Axxess OESWC-7552-STK Manual de instrucciones de instalación - Página 5

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Piezas de automóviles Axxess OESWC-7552-STK. Axxess OESWC-7552-STK 8 páginas. Axxess interface automobile parts - car parts user manual

Imprimir página

8. Make sure the steering wheel control buttons function correctly in the

vehicle and enjoy your radio.

If the ASWCSTALK is mounted on the right side of the steering column

follow the instructions below. (Auto-detect must be done first)

Turn the ignition on

Press the MODE on the ASWCSTALK for 10 seconds

Then press volume up for 2 seconds

The ASWCSTALK is now configured for the right side.

Troubleshooting the Auto Detect Mode

So you tried the auto detect feature and at the end the led did not stay on

solid red, it started flashing, or the steering wheel controls did not function

properly. That means the interface did not detect the ASWCSTALK or the

proper radio. Follow these steps to determine what happened:

First some basic tips:

1. Verify that you have 12 volt accessory and a good ground to the

ASWCSTALK and interface.

2. Verify that the 3.5mm connector is connected to your radio securely

and in the correct location.

3. If using the female 3.5mm connector on an Eclipse or Kenwood radio,

verify that the radio's SWC wire is connected to the correct wire on

the interface.

Once all the information above has been verified and correct, you

will need to put the interface back into auto-detect mode. Follow the

instructions from "If the ASWCSTALK was installed before" section above,

however this time take notice of the led flashes in steps 5 and 6.