DigiDesign VENUE AO16 Manual - Página 10

Navegue en línea o descargue pdf Manual para Tarjeta de sonido DigiDesign VENUE AO16. DigiDesign VENUE AO16 12 páginas. Analog output card for venue mix rack and venue sc48

Imprimir página

Remove the card from its packing material. Hold the card by

its edges.

Connect the ribbon cable to the card socket. Make sure the

pins on the socket are correctly aligned with the ribbon cable

connector. The retaining clips on each side of the socket con-

nector automatically close when the cable connector is prop-

erly seated. Check to make sure the ribbon cable is connected

securely.

Connecting the ribbon cable to the card socket

Slide the output card into the slot, firmly pressing on both

ends of the card so that it fits snugly in the slot.

Installing the AO16 Card

Secure the card to the rear panel using the four screws you

removed earlier.

AO16 Analog Output Card

Completing and Confirming Installation

To complete and confirm installation:

Reconnect the power cable and any other cables to the

SC48.

Turn on your SC48.

Go to the Options page and click the Devices tab to view

your system hardware status. The newly installed card should

be displayed.

If the card does not appear in the graphic, check the ribbon

cable connection. Shut down your system, then disconnect

and reconnect the ribbon cable to the output card, making

sure to seat the connector properly in its card socket.

Detail of Devices tab indicating presence of two AO16 Cards output

slots D and E

Go to the Patchbay page and click the Stage tab to verify

that the output card outputs are available in the patchbay.

In the standalone software, click the Devices tab on the Op-

tions page. You can right-click the SC48 graphic to see and

modify your SC48's input and output card configuration.

Detail of standalone software's Devices tab pop-up menu showing two

AO16 Cards