CREE LIGHTING FLEX FLX22 Instrucciones de instalación - Página 2
Navegue en línea o descargue pdf Instrucciones de instalación para Equipos de iluminación CREE LIGHTING FLEX FLX22. CREE LIGHTING FLEX FLX22 4 páginas. Commercial specification troffers with emergency driver
Imprimir página
TO INSTALL:
1
Luminaire Hooks
2
Cable Slots
T- BAR CEILING MOUNTING
STEP 1:
Bring the FLEX troffer up into the T-Bar grid.
STEP 2:
Locate the luminaire hooks and bend them out 90 degrees for
installation. See Figure 1.
NOTE: The luminaire hooks ship bent in and need to be bent out for
installation.
STEP 3:
Then bend the luminaire hooks against the T-Bar to secure the
luminaire. See Figure 1.
SUSPENDED MOUNTING
STEP 1:
Attach customer supplied cables to the (2) cable slots on each side of
the housing. See Figure 2.
STEP 2:
Attach customer supplied cables to mounting surface using customer
supplied hardware. Ensuring that mounting surface can support the
luminaire.
2 of 4
T-bar
1st:
90° Bend
2nd: Bend
Against T-bar
T-bar
Dimming Wire
3
Junction Box Cover
0 - 10V DIMMING OPTION
STEP 1:
Remove the cover of the junction box and bring in appropriate power
supply to the junction box using one of the knock-outs. See Figure 3.
STEP 2:
Remove the cover of the dimming junction box and bring dimming
conduit into dimming wire compartment using the knock-out. See
Figure 3.
STEP 3:
Wire luminaire per "Electrical Connections" section and push all leads
into the junction box. Reattach junction box cover that was removed in
Step 1 , make sure no wires are pinched.
STEP 4:
Install test switch assembly into ceiling by drilling a 1" hole into the
ceiling.
STEP 5:
Unscrew the small trim ring and place test switch assembly through the
ceiling. See Figure 4.
STEP 6:
Secure the test switch assembly by screwing the small trim ring
removed in Step 5 back onto the test switch assembly. Tighten the larger
trim ring above the ceiling until it is snugged tight against the ceiling.
See Figure 4 on the next page.
Power Supply
Junction Box Cover
LPN00439X0001A1_C