Digiflex SMART RF RF120 Manual de referencia del instalador - Página 3

Navegue en línea o descargue pdf Manual de referencia del instalador para Transceptor Digiflex SMART RF RF120. Digiflex SMART RF RF120 8 páginas. Base station with relay outputs

Imprimir página

ers as required in strategic locations. Up to 4 receiv-

ers can be added.

Installation

The receiver should be installed onto a solid surface

using suitable mounting fixtures. Wiring should only be

performed while the control panel is powered down.

Step 1) Unlock and remove the front of the housing by

turning the cam lock anti-clockwise [Figure 4]

then release the spring clips and remove the

PCB, This will expose the mounting and tamper

screw holes.

Step 2) Mark out the location of the mounting holes

and the cable exit hole before drilling out all

Figure 4: Cam Lock Shown

In The Unlock Position

CAUTION - Figure 3 below is a guide only and is not a 1:1

mounting template for the RF120/RF121. Do not scale.

Figure 3: Mounting Holes, Cable Knock

Out's & Rear Tamper Locations

E&OE

points as necessary. Secure the case using fix-

tures appropriate for the wall construction type.

Make sure to fit the rear tamper screw when

mounting as shown.

Step 3) Feed any wires into the case via the knockouts

provided and then replace the PCB by inserting

from the terminal side first and then clipping

the other side in.

Step 4) Set the address for the module and connect

and necessary wiring. Unused wires should be

insulated to prevent short circuits.

Step 5) Once all connections are secure and the case is

mounted, secure the front case and lock in place

by turning the cam lock in a clockwise direction.

Rear

Tamper

Mounting

Holes

Cable

Knock Outs

Cable

Knock Outs

Figure 5: Rear Tamper Screw

P/N: RF120-RF121IRG Rev 1.30

Page

