Creek Audio VOYAGE i20 Manual de instrucciones - Página 12

Navegue en línea o descargue pdf Manual de instrucciones para Amplificador Creek Audio VOYAGE i20. Creek Audio VOYAGE i20 19 páginas.

It is important not to short-circuit the loudspeaker cables together when the amplifier is powered. The short circuit (over-current) protection

will prevent damage but, it is better to be avoided if possible. Ensure there are no strands of wire bridg¬ing the terminals when connecting the

loudspeakers and make all connections with the amplifier turned-off or in Standby mode. If it is necessary to change or move the location of the

loudspeakers, make sure that you first turn the amplifier off and double check the wiring before powering up again.

REMOTE CONTROL

The handset allows the user to operate the amp remotely via an infra-red signal. The handset must be pointed approximately at the front panel

for best performance. Range is limited to about 7 metres, or 23 feet. The Creek remote is designed to be intuitive in use. However, it is sometimes

necessary to press the appropriate coloured button at the top of the remote first to select Amp (Blue), CD/DAC (Black). Note – not all the buttons

and functions work for the Voyage, as the remote is universal and used by other Creek products.

The Creek remote transmits standard Philips RC5 type remote control codes.

The Voyage remote handset will also control other Creek products, like the Evolution 50/100A and CD, plus Destiny 1 and 2 and some older mod-

els as well. Contact [email protected] for advice if in doubt.

RC BUS – REMOTE CONTROL SENSOR EXTENDER

The amplifier is supplied with a remote extender. If there is no clear sight of the front panel, the sensor head can be placed where it can be seen,

and the amplifier hidden away. The extender jack should be plugged into the socket on the rear panel marked RC Bus IN. An RC bus OUT socket

allows the amp to be chain linked to a matching Voyage CD, where only one remote sensor will operate two products to prevent the possibility of

the two products becoming un-synchronised, i.e. one switched on and the other switched off. If in doubt, please write to: [email protected]

for further advice.

HEADPHONES

Most types of headphones (from low to relatively high impedance) can be enjoyed with the i20 through its dedicated high-quality headphone

amplifier. Volume is controlled as usual by the left-hand control knob. The 6.35mm (1/4") socket is located on the left-hand end of the display

window.

The i20 has a dedicated headphone amplifier built into its pre-amplifier circuit capable of driving most types of headphones. Gain or loudness