Creek Audio Classic Tuner Manual de instrucciones - Página 2

Navegue en línea o descargue pdf Manual de instrucciones para Sintonizador Creek Audio Classic Tuner. Creek Audio Classic Tuner 4 páginas.

FRONT PANEL

Tuning / Pre-sets station selection, by rotary control knob, is switched by the Mode selector.

2. Mode selector push button changes the function of the rotary control from tuning to pre-set station selection and back again.

3. Band push button selects FM, MW and LW for Europe, or FM/AM for North America and countries without LW. Custom frequencies

and bands for other locations are factory set, but Creek dealers can re-programme them if you have to move to a different zone.

4. Search Up / Down push button tunes up or down automatically, stopping on each usable station and rolling over at band ends.

5. Display push buttons allows a selection of display brightness settings, from off to fully bright.

6. Store allows selected stations to be memorised by the tuner in pre-set channel locations, separately on each wavelength.

7. Display window contains frequency, channel and RDS Station ID, plus centre tuning information and all other function status in a

highly visible green display.

8. Infra-Red sensor can receive remote control (RC5) instructions of all functions. See remote control notes.

9. Standby switches the tuner from Standby to On and back again.

Mains inlet and power switch

OPERATING THE CLASSIC TUNER

Manual & Pre-set Operation

The large control knob on the right side of the panel has two

functions. First it will manually tune the radio up and down

smoothly to receive stations on FM or AM displaying the

frequency, band and centre tuning

RDS station name, if transmitted, will also be displayed

together with the stereo 'ST' or mono status.

The second function is to select Pre-Set stations from the

tuner's memory, acting like a rotary switch.

The frequency of the station will be displayed for a few seconds

and may be replaced with the station ID. The Pre-Set channel

will only show when the tuner is in Pre-Set mode, selected by

the MODE button (which toggles between the two functions).

The T50 will remember the last tuned frequency, station ID or

pre-set after switching off, so it can be restored when switching

back on.

Note: The last tuned station will only be remembered if it has

been left unaltered for 1 minute before switching off.

Audio outputs

Pre-Set

Antenna inputs

Station ID

Frequency