FIALA MOTORS Valach Motors VM R5-420 Manual - Página 5

Navegue en línea o descargue pdf Manual para Motor FIALA MOTORS Valach Motors VM R5-420. FIALA MOTORS Valach Motors VM R5-420 10 páginas.

FIALA MOTORS Valach Motors VM R5-420 Manual
Manual for motor FM_VM R5_R7 ( Date of publication 01/2018)
-
set a slightly increased idle speed of about 3-8% (must be tested on a specific motor)
-
turn the ignition
-
start the motor

Warm motor - up to 4 minutes of engine styling

-
turn the ignition
-
set a slightly increased idle speed of about 3-8% (must be tested on a specific motor)
-
start the motor

Warm motor - five minutes after the engine stalling

Make sure that the ignition is switched off

-
close the choke
-
1 x spin the motor
-
open the choke
-
set a slightly increased idle speed of about 3-8% (must be tested on a specific motor)
-
turn the ignition
-
start the motor
If a situation arises that the engine will not start, there was either a glut motor fuel, or vice versa
engine is lean.
Because these conditions can be difficult to detect, we recommend the following procedure:
-
check the fuel system (leaks, throughput, level of fuel etc.).
-
make sure that the ignition is switched off
-
set full throttle
-
10 x spin the motor
-
turn the ignition
-
set a slightly increased idle speed of about 3-8% (must be tested on a specific motor)
-
start the motor
If the engine can no longer run, we recommend:
Make sure that the ignition is switched off
-
close the choke
-
3-4 times to spin the motor, in order to draw fuel
-
open the choke and set the throttle
-
1 x spin the motor
-
set a slightly increased idle speed of about 3-8% (must be tested on a specific motor)
-
turn the ignition
-
start the motor
FIALA PROP s.r.o, Vysoká 56, 75641 LEŠNÁ , Czech Republic , e-mail: [email protected]
www.fialaprop.com
Page 5