Cres Cor H138NPSCDOM2MQCE Manual de instrucciones de funcionamiento y mantenimiento - Página 4
Navegue en línea o descargue pdf Manual de instrucciones de funcionamiento y mantenimiento para Equipamiento alimentario comercial Cres Cor H138NPSCDOM2MQCE. Cres Cor H138NPSCDOM2MQCE 12 páginas. Hot cabinet
Imprimir página
FL-2344-DOM
Holding Cabinet
Rev. 4 (4/10)
Page 4 of 12
INSTALLATION & OPERATION INSTRUCTIONS
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with the
appliance.
INSTALLATION:
1. Remove all paper and packing material from inside
of cabinet.
2. Remove protective paper and vinyl material from
outside surfaces of cabinet.
3. Place the cabinet in a well-ventilated area.
4. Place cabinet on level floor.
5. Plug cord end into proper wall outlet.
CAUTION
Do not reverse door openings.
It may result in injury.
5925 Heisley Road • Mentor, OH 44060-1833
NOTE:
Our products have been evaluated to the WEEE directive. We have
also reviewed our products to determine if they comply with the
Restriction of Hazardous Substances directive (RoHS) and have
redesigned our products as needed in order to comply. To continue
complaince with these directives, this unit must not be disposed as
unsorted municipal waste. For proper disposal, please contact The
Authorized Agent:
Eurocatering Equipment Limited
Unit 3 Turnpike Close, Off Bilton Way
Lutterworth Leicestershire, LE17 4YB
OPERATION:
FIRST TIME START-UP:
1. Push the POWER switch to "ON", and run the
cabinet for one hour.
NOTE: DO NOT PUT FOOD INTO THE CABINET!
2. Let the cabinet cool and wipe the inside clean with
detergent and hot water before first use.
WARNING
Blower inlet guard must be in place before
operating cabinet.
WARNING
United Kingdom
This step is to burn off manufacturing oils and
excess adhesive.
Air is VERY HOT
when door is opened.