Cres Cor AquaTemp CO-151-FWUA-12DX2081BC Manual de instalación, uso y mantenimiento - Página 8
Navegue en línea o descargue pdf Manual de instalación, uso y mantenimiento para Horno de convección Cres Cor AquaTemp CO-151-FWUA-12DX2081BC. Cres Cor AquaTemp CO-151-FWUA-12DX2081BC 17 páginas. Humidity convection ovens
Imprimir página5925 Heisley Road • Mentor, OH 44060-1833
OPERATING INSTRUCTIONS (continued)
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
12 . Pressing DISPLAY button will allow the user to see the
following values:
a . "s" hold temp setpoint
b . "t" hold time
c . "A" actual oven temp
d . "c" time the unit was in the cook cycle
e . "H" probe max temp
f . "L" probe min temp
NOTE: Cycling through all the parameters back to the
default display will make the screen alternate
between hold temp setpoint and time . If desired,
user can leave any above desired display
parameter on the screen and it will remain there
(not revert back to default display) .
13 . Hold mode will count up indefinitely or until power
switch is turned OFF or a new cook cycle is started .
Typically during this time is when the product is
removed from the oven .
a . To begin a new cook cycle, press START . Unit will
begin PREHEAT the previous parameters .
b . To end the hold cycle and allow the oven to idle at
hold temperature, press CANCEL .
NOTE: At any time, press CANCEL to idle the oven at
hold temperature . Editing recipes, getting into the
menu, or starting a new cycle can be done at this
time .
CAUTION:
This trial unit uses prototype software. If the controls
freeze up or something is happening that shouldn't,
please turn the power switch OFF. Do not re-start oven
for at least 30 seconds. Any fault should be cleared.
Convection
FL-2373-BC
Humidity Oven
Page 8 of 17
Rev. 1 (8/20)