Digilin LDMX-PWM-3 Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Receptor Digilin LDMX-PWM-3. Digilin LDMX-PWM-3 9 páginas. Dmx receiver with 3 channel, pwm driver

Imprimir página

User Manual

DMX Recei v er w i th 3 Channel PW M Dr i v er

6 M ay 201 3

Using With Colour Theme Inp ut

In order to connect a Colour Theme Controller the DMX address should be set to 1

and the Input Select Switch (switch 10 of the DMX address switch, as shown in

Figure 1) should be in the up position. When data is being correctly received, the

green LED should be on. It is possible to connect further DMX receivers to this unit.

They should be configured to operate with a standard DMX input (not a Colour

Theme Input) with the DMX address set to 1.

Using With DMX Inp ut

In order to use the LDMX-PWM-3 with a DMX feed simply set the desired address

and connect the DMX feed to the DMX input. Remember to terminate the DMX feed

at the end of the chain with a 120Ω resistor between the DMX + & - lines. When data

is being correctly received, the green LED should be on.

T est Mode

The LDMX-PWM-3 has test mode which ramps each individual output up to full

brightness then back off in sequence. This test mode is entered by setting the DMX

address to 0 (all switches down). While in this mode, any incoming DMX data is

ignored. Once the address is changed from 0, the unit will complete the current cycle

of the test, then return to normal operation.

Fallba ck Outp ut

By default, the LDMX-PWM-3 outputs will be set at 50% for all channels at start-up

and loss of DMX signal.

d i g i l i n . c o m . a u

P a g e 4 o f 9