Cres Cor Hand-Lift Cabinet H-339214 Instrucciones de uso y mantenimiento - Página 3

Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Calentador de alimentos Cres Cor Hand-Lift Cabinet H-339214. Cres Cor Hand-Lift Cabinet H-339214 4 páginas. Cres cor hand-lift cabinet operating and maintenance instructions

Imprimir página
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
For INSULATED HAND-LIFT CABINET; MODEL H-339214
HOW TO REVERSE DOOR HARDWARE
FOR OPPOSITE HAND (Refer to Fig. 3 [hinge]):
1.
Pop off hinge covers with screwdriver.
2.
Remove screws from hinges to cabinet; remove door
and unscrew latch strike from cabinet.
3.
Remove hinges, latch and all remaining screws from
the right and left side of door. Keep all screws.
4.
Re-mount hinges and latch in the same hole pattern on
the opposite sides of the door. Plug all extra holes with
screws.
5.
Remove all screws from the front sides of cabinet (not
the top and bottom).
6.
Hold door up to cabinet and screw hinges to the
cabinet.
7.
Open door and re-mount the latch strike to cabinet.
8.
Plug all extra holes with screws and snap on the hinge
covers
.
REPLACEMENT PARTS
Cord Set.................................... H339214-08
Switch....................................... 0808-113
Heater Kit..................................0811-066-K
Thermostat Kit.......................... 0848-062-K
Terminal Block..........................0852-091
Thermometer.............................5238-030
Door Latch Kit.......................... 1006-122-01-K
Strike Kit...................................1006-122-02-K
Hinge Kit...................................0519-074-K
Gasket Kit................................. 0861-077
Casters.......................................0569-306
Casters w/Brake........................ 0569-306-B
Door Replacement Kit.............. 5508-084-SS
Rack Insert................................ 1170-122
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
DOOR
TOP
FIGURE 2
TROUBLE-SHOOTING CHART
FAILURE
1. Unit does not heat:
2. Unit will not turn off: 2a. Thermostat turned down.
If cause is none of the above, refer to our list of
authorized service agencies, FL-1400.
Instructions for replacing parts are included in
replacement parts kits.
Insulated
FL-0520-12
Hand-lift Cabinet
Rev. 3 (1/09)
Page 3 of 4
CABINET
BODY
HINGE
COVER
POSSIBLE CAUSE/CHECK
1a. Thermostat turned up.
1b. Switch is "ON".
1c. Cord is plugged into outlet.
1d. Circuit breaker/fuse for
wall outlet
2b. Switch is "OFF"