FIAMA SIMPLEX-E 50 Manual de usuario y mantenimiento - Página 5

Navegue en línea o descargue pdf Manual de usuario y mantenimiento para Monitor FIAMA SIMPLEX-E 50. FIAMA SIMPLEX-E 50 8 páginas.

SIMPLEX-E

Display for linear measurement

Adjusting of quota

After the assembling of instrument on the machine and setting of all parameters, to visualize on the display

the correct measure it is necessary to carry out the reset or preset of quota. Position the transducer in point

where is known exactly the correct measure to display (ex. check-stroke) or measure the quota in that point

of the axis.

Programme parameter

with value 3 in the first digit on the right and go out of the programming.

Now press

and it will appear Preset, press again 2 times

and set on the display the correct

RESET

measure to visualize, confirm with

and on the display appears the correct measure.

RESET

If the adjusting quota is worth to zero instead of the preset is possible use reset, setting value 1 on the first digit

on the right of

, this way pressing

the value on the display will be zeroed.

RESET

Now that the instrument is adjusted its necessary re-establish to the wanted value parameter

to avoid

accidental reset/preset of quota.

Battery change

The instrument is supplied with 2 batteries type AA of 1,5V (alkaline type) which assures a functioning of

about 1 year. When the loading level goes under a certain value, the indicator of flat-battery begins to blink in

occasional way and when it keeps switched on its necessary to change the batteries within a month.

To enter into the battery-holder its necessary to take off the cover and screw-off the 4 seal-screws on the two

hollows placed on a side of the instrument.

Take off the cover and take out the battery-holder and change the batteries paying attention to the polarity

indicated. Without batteries the instrument switches off: in this phase do not rotate the hollow shaft to avoid

loosing of correct quota.

As soon as the batteries are fitted inside, the instrument switches on with the same value on the display as at

the moment of the switching off and if the shaft has not be moved the value will be correct. In case the shaft

is moved during the switching off, to re-establish the correct measure its necessary to repeat the adjustment

proceeding.

Rotation of display

The Simplex-E is supplied standard with mounting position A.

To modify assembling position to A in B or vice versa, screw off the 4 screws M3, turn the instrument to the

required position and screw again.

Data: 13/01/16

file: Simplex_ing.doc

pag 5/8